Feather is the flagship development board from Adafruit and like its namesake it is thin light and lets you fly! Feather was designed to be a new standard for portable microcontroller cores. This is the Assembled Adafruit Feather HUZZAH ESP8266 (Headers not included) Adafruit's take on an 'allinone' ESP8266 WiFi development board with built in USB and battery charging and ready to go immediately! Its an ESP8266 WiFi module with all the extras you need ready to rock! At the Feather HUZZAH's heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack. You can program the microcontroller using the Arduino IDE for an easytorun Internet of Things core. The USBSerial chip is wired up for an upload code at a blistering 921600 baud for fast development time. It also has autoreset so no noodling with pins and reset button pressings. To make it easy to use for portable projects there's a connector for any 3.7V Lithium polymer batteries and built in battery charging. You don't need a battery it will run just fine straight from the micro USB connector. But if you do have a battery you can take it on the go then plug in the USB to recharge. The Feather will automatically switch over to USB power when its available. Here's some handy specs! Measures 2.0 x 0.9 x 0.28 (51mm x 23mm x 8mm) without headers soldered in Light as a (large?) feather 9.7 grams ESP8266 @ 80MHz with 3.3V logic/power 4MB of FLASH (32 MBit) Built in WiFi 802.11 b/g/n 3.3V regulator with 500mA peak current output CP2104 USBSerial converter onboard with 921600 max baudrate for uploading Autoreset support for getting into bootload mode before firmware upload 9 x GPIO pins can also be used as I2C and SPI 1 x analog inputs 1.0V max Built in 100mA LiPoly charger with charging status indicator LED can also cut a trace to disable the charger Pin #0 red LED for general purpose blinking. Pin #2 blue LED for bootloading debug & general purpose blinking Power/enable pin 4 mounting holes Reset button
