Brand: K-Rain SKU: 2510Product OverviewThe K-Rain 2510 is a rain-switch-ready mechanical single-station controller for scheduling one compatible 110-volt irrigation load. It is designed for applications that need dependable mechanical programming plus a convenient way to interrupt watering when a compatible rain sensor indicates that irrigation is unnecessary.The controller accepts 110 VAC input and switches 110 VAC output for an approved motor load rated up to 2 horsepower. A 24-hour dial supports multiple start settings, while retained pins provide a repeating 14-day watering schedule. Built-in rain-switch terminals simplify sensor connection, and the controller-face override allows the rain-switch circuit to be managed without rewiring the installation.The 2510 directly switches a line-voltage load; it is not a standard 24 VAC zone controller. A rain sensor is not included. Before ordering, verify that the connected pump or other equipment uses 110 VAC, falls within the controller's load rating, and is suitable for the double-pole, single-throw switching configuration. Installation requires proper grounding, overcurrent protection, enclosure placement, and compliance with electrical and irrigation codes. Line-voltage work should be performed by a qualified professional using the current K-Rain instructions.Key Features 110 VAC input and 110 VAC switched output Compatible motor-load rating up to 2 HP Double-pole, single-throw switching Rain-switch terminals with face-mounted override 24-hour mechanical dial with multiple starts Repeating 14-day retained-pin schedule Rain-tight enclosure for approved installations Common Uses Single 110V irrigation pump scheduling Pump-fed indexing-valve systems Adding rain-sensor interruption to a mechanical controller Replacing an exact K-Rain 2510 controller Compatibility and Installation Notes Confirm 110 VAC supply voltage and a compatible load no greater than 2 HP. The rain switch and any required pump starter are sold separately. This model does not directly provide a conventional 24 VAC valve-station output. Use only compatible rain-switch wiring and follow the current K-Rain diagram. Disconnect power and use a qualified professional for line-voltage installation. Frequently Asked QuestionsDoes the K-Rain 2510 include a rain sensor?No. It is rain-switch ready, but the compatible sensor is purchased separately.Is the output 24 volts?No. The 2510 accepts and switches 110 VAC. It should not be confused with K-Rain transformer models that provide a 24 VAC output.Can the rain switch be bypassed?The controller includes a face-mounted rain-switch override. Follow the K-Rain instructions and use the override only when appropriate for the site.Why Buy This K-Rain 2510 from Big Frog Supply?Big Frog Supply identifies the 2510 by its exact 110V input/output, 2 HP load rating, and rain-switch-ready configuration. That helps prevent substitution with visually similar K-Rain timers that use different voltages, transformer outputs, or motor ratings.
