Description Cross Reference Information for Inducer Motor (318984-753): 318984-753. 2347563, 3195827, HC21ZE117, K674, 10704, TJ318984-753, AP5634784, 318984753, 323435-730, 323435730, 323435-724, 323435724, 323435-701, 323435701, HC21ZE114, 321373-712, 321373712, HC21ZE114A, 321373-711, 321373711, 321373-710, 321373710, 321373-709, 321373709, 321373-708, 321373708, 321373-707, 321373707, 321373-706, 321373706, 321373-705, 321373705, 321373-704, 321373704, 321373-702, 321373702, 321373-701 & more! Cross Reference Information for Blower Wheel (LA11AA005): P441-1146, LA11AA006, LA11AA004 Quality you can Trust! All Snap Products are made with premium materials and are tested so they last. Compatible with the following HVAC brands: Carrier, Bryant, Payne. Just because parts look the same does not mean that they are the same. Use the model numbers below to ensure that this part is compatible with your appliance! All Snap parts come with installation instructions to help you with your repair. If you need more help, you can always contact us for further assistance. Email us at [email protected] or give us a call at 1-802-727-4126. Installation Instructions Installation Instructions for 318984-753 Disconnect electrical power supply to the appliance Remove the access panel to the HVAC System Remove motor from housing by removing all the screws holding it in place, typically, 3-4 Pull motor out and unscrew wheel from motor shaft. (there is a gap in the wheel to reach). If you cannot get screw to budge stop here and buy the wheel that goes with it. If you cannot get the wheel to come off use a saw to cut the shaft from the old motor. Unscrew the 3 screws holding the motor to the plate plus ground wire Flip motor over remove 2 screws holding motor to second plate Take motor out and put new one in place and start screw the 2 plates back on Once motor is secured to the 2 plates attach the wheel to the shaft. Make sure you test that the wheel is tight and will not slip on shaft! Attach plastic wheel to back of motor and secure it in place with the metal clips. Hand spin wheel to make sure everything rotates smoothly with no wobble Install motor back into the HVAC unit attach cords to the 2 terminals and give it a test! Installation Instructions for LA11AA005 Disconnect electrical power supply to the appliance remove the access panel to the HVAC System Remove motor from housing by removing all the screws holding it in place, typically, 3-4 Pull motor out and unscrew wheel from motor shaft. (there is a gap in the wheel to reach). If you cannot get screw to budge stop here and buy the wheel that goes with it. Make sure you test that the wheel is tight and will not slip on shaft!. Hand spin wheel to make sure everything rotates smoothly with no wobble Install motor back into the HVAC unit attach cords to the terminals and give it a test! Shipping
Related
Related
Related
Related