3D ONE is like no other compound or polish you’ve ever used, and you’ll find this out the first time you use it. 3D ONE cuts like a compound and finishes out like a fine cut polish. Other companies have tried to create a product like 3D ONE in the past, but no one even comes close to 3D ONE. To change the cut simply change the pad or tool. That’s right, change the tool. For super aggressive cut, use 3D ONE with a rotary polisher and a traditional 4-ply, twisted wool cutting pad. For less cut, use any orbital polisher with either a fiber pad or a foam cutting pad. For polishing and show car finishing work, switch to your favorite orbital polisher and a soft foam polishing of even softer foam finishing pad. Combination hybrid compound/polish – Can cut like an aggressive compound or finish-out like a fine-cut polish – in a single product. Uses engineered ceramic alumina abrasives, which reduce surface temperature. Forever buffing cycle – stays active and wet on the surface as long as you buff. ZERO dusting. Note the word ZERO is in all CAPITAL LETTERS! Easy wipe-off and no hurry – wipe off immediately or after buffing out entire car. Versatile cut – for more correction use a cutting pad, for better finishing, use a finishing pad. No fillers – the results you see are true and accurate. Body shop safe – contains no silicones or any ingredient that can contaminate a fresh paint environment. Water-based for easy clean-up Green technology is Earth friendly – V.O.C. compliant, and biodegradable. Directions: IMPORTANT: Always work on a clean, cool surface in the shade. Car should already be washed and dried and if needed, use detailing clay first to remove any above surface bonded contaminants. By orbital polisher Step 1: Apply 4-5 nickel sized drops of product to the face of the pad. Step 2: Using a slow to medium speed, spread product out over a section of paint no larger than 2’x2’. Step 3: Turn polisher to high speed and begin working the product over the panel using an overlapping, crosshatch pattern for 2-4 minutes. Step 4: Move onto a new section of paint and repeat the above process until an entire panel has been worked with 3D ONE. Step 5: For best results, remove residue immediately after buffing using a clean, dry microfiber towel. Turn the towel over or fold to a clean side often. For best results, use plenty of clean, dry soft microfiber towels. By rotary polisher Step 1: Apply a circle of product around the middle of the face of the pad. Step 2: Using a slow to medium speed, spread product out over a section of paint no larger than 2’x2’. Step 3: Using a low to medium speed, begin working the product over the panel using an overlapping, crosshatch pattern for 2-4 minutes. Step 4: Move onto a new section of paint and repeat the above process until an entire panel has been worked with 3D ONE. Step 5: For best results, remove residue immediately after buffing using a clean, dry microfiber towel. Turn the towel over or fold to a clean side often. For best results, use plenty of clean, dry soft microfiber towels. Repeat this process to the rest of the vehicle. SDS SHEET: 3D ONE
