Electronic parts made by Sakatsu, non-scale Just insert the batteries and enjoy the 5 LED lights in the "Lighting 5" set, which includes a mounting stand to make installation even easier. The height can be changed in six steps (maximum height approx. 5cm), allowing you to install and fix the LEDs at the desired height, creating a realistic indoor lighting effect. No soldering required, 5 light bulb LEDs with a chip size of 3.2mm x 2.8mm (thickness is approx 3mm including leads), all pre-wired and ready to use! 3 x AAA batteries (not included) provide up to 36 hours of continuous light! (Battery life may vary and is not guaranteed.) The length of the lead wires is approximately 30cm for each of the 5 LEDs and 1 switch, making them easy to place. (Power supply board size: 50mm x 75mm) LEDs are ideal for use in models as they save power, have a long life and generate very little heat compared to bulbs. The chip LED has a manufacturer's nominal light diffusion angle of 120 degrees, allowing it to project light over a wider area than a typical bullet-shaped LED (40-60 degrees). Note: To reduce the height, please cut off the unwanted part of the pillar parts. Note:Specifications are subject to change without notice. Information edited by Sakatsu Gallery Simply insert three AAA batteries (not included) and enjoy five LED lights Lighting 5 and a Includes mounting base for easier installation. The height of the LED can be changed in 6 steps, allowing you to install the LED at your preferred height and create a realistic interior light. You can choose from a wide range of colours, more colours, flashing lights, flames and more. ubstrates Always On 10 PCB Blink Control Super 8 flickering light board Battery Case
