Description This part is responsible for letting water into the washing machine. These parts might need replacement if your washer is not filling properly, or if it isn’t filling at all. Cross Reference Information 5220FR2008F, AP4445613, 1268512, 5221ER1002B, AH3527431, EA3527431, PS3527431 Quality you can Trust! All Snap Products are made with premium materials and are tested so they last. Click here for installation instructions! Compatible with the following Washer brands: LG Just because parts look the same does not mean that they are the same. Use the model numbers below to ensure that this part is compatible with your appliance! All Snap parts come with installation instructions to help you with your repair. If you need more help, you can always contact us for further assistance. Email us at [email protected] or give us a call at 872-231-0086. Model Numbers Use ctrl+F then enter your model number in search bar and hit enter 79640441900 79640448900 79641022900 79641028900 79641029900 79641542110 79641548110 79641549110 79642192900 79642198900 79642199900 WM0001HTM WM0001HTMA (ASTEEUS) WM2450HRA WM2487HRM (ACREEUS) WM2487HRMA (ACREEUS) WM2487HWM (ABWEEUS) WM2487HWMA (ABWEEUS) WM2487WHM WM2497HWM WM2501HVA WM2501HWA WM2688HNM (ANBEEUS) WM2688HNMA (ANBEEUS) WM2688HWM (ABWEEUS) WM2688HWMA (ABWEEUS) WM2801HLA (ARBEEUS) WM2801HRA (ACREEUS) WM2801HWA (ABWEEUS) WM2901HVA WM3001HPA (APTEEUS) WM3001HRA (ACREEUS) WM3001HWA (ABWEEUS) WM3360HRCA WM3360HVCA WM3360HWCA WM3550HVCA WM3550HWCA Installation Instructions Installation Instructions for 5220FR2008F Tools Needed: Screwdriver Flat end screwdriver Pliers Unplug appliance and/or turn off circuit breakers to prevent electrocution. Turn off water supply from washer With a pair of pliers, unscrew the cold-water inlet hose. Be careful as water may fall out, a towel is recommended. With a screwdriver, remove the two lower bracket screws, pull back the top panel and lift off the washer. Taking a picture is recommended to know how the hose and plugs are installed. Remove the four plugs with flat head screwdriver, remove the wire harness from the clips, with pliers slide the hose clamps, place towel under water valve and with flat head screwdriver remove the hose. Remove the two screws holding the valve and remove the valve. To install the new water valve, secure it with two screws. Install the four hoses and secure the hoses with pliers, remove the towel. Connect the wire plugs and place the wire harness into the clips. Place top panel on, push it in and secure it with screws. Install the water inlet hose and tighten it with pliers. Be careful not to tighten it too much as it may cause a leak. Turn water supply back on, plug appliance back in and appliance is set to go!
