Well suited for automated equipment although excellent results can be achieved inalmost any printing operation. SOFT-HAND PRINTS For softer feeling prints on light colored fabrics, use 20% to 25% by volume of 720Softhand Clear Base. Reducing the viscosity of the ink using 1110 Curable Reducer andprinting through finer mesh counts can also greatly improve the softness (hand) of thefinished print. SPOT FLASHING The 700 Series inks will spot dry, with a very low after flash tack. Dwell time is dependenton the spot dryer used. In some cases, you may have to lower the heat of the spot cureunit because too much heat may actually make the ink tacky. When you spot dry, you areonly partially fusing or gelling the surface of the ink. The ink should be just dry to thetouch, with no lift-off, RECOMMENDED FABRICS 100% Cotton 50/50 Cotton/Polyester Blends INK APPLICATION 700 Series Colors should be printed without any modifications ADDITIVES If modification is necessary, use 1% to 3% by weight of 1110 Curable Reducer for the standard inks and 1099 Low Bleed Curable Reducer for the HP inks SCREEN MESH Standard Colors: 110-305 t/in (43-120 t/cm) monofilament HP Colors: 61-110 t/in (24-43 t/cm) monofilament EMULSION Any direct or indirect emulsion or capillary film in the 35 to 70 micron range, depending on the opacity desired SQUEEGEE 65-70 Durometer Sharp edge CURE TEMPERATURES 325°F (163°C) entire ink film CLEAN-UP Any eco-friendly plastisol screen wash PRODUCT PACKAGING Quart, 1 gallon, 5 gallon, 30 gallon or 50 gallon containers STORAGE OF INK CONTAINERS 65º to 90ºF (18ºC to 32ºC) Avoid storage in direct sunlight Keep containers well sealed
Related
Related
Related
Related