A1 All In One by Innovacar is an intermediate car polish and one step can also be used in the polishing process. A quick and easy abrasive paste that combines cutting capacity with a quality finish, without silicones. Main features: All in One: is a polish that can correct, polish and finish the car bodywork in a single product. Suitable as a balanced polish: it can be used as an intermediate abrasive paste in the second step of the classic polishing process. Layered grain technology: the grain of the polish is initially large and sharp. It breaks by friction and releases a smaller but also sharp internal grain. The stratification continues gradually and the grains get smaller and smaller but still active. Excellent performance: removes scratches and oxidation, combining an incomparable finish, without marks and holograms. Suitable for rotary and rotary-orbital: it is a polish that can be used for both types of polisher. Summary technical data: Removes scratches: YES High finish: YES Quick application: YES Cut: 5/6 Finish: 5/6 A1 ALL IN ONE IS IDEAL TO Have a product that can be used in both cutting and finishing. For maximum effects, simply change the type of pad: medium-hard orange for cutting, medium-soft blue for finishing. Reduce and sometimes remove any damage caused by sanding with sandpaper of up to 2000 grit. Having a versatile product, usable both with rotary polishers and with rotary-orbital polishers. Polish the paint, reducing the amount of generated dust and finish directly without additional steps. HOW TO USE A1 ALL IN ONE How to polish your car in one step with A1 All in One: Carry out all the preliminary steps to polishing such as: pre-washing, washing and chemical and mechanical decontamination of the car, for which DL Lube and the Clay Bars are recommended. Shake the product before use. Apply the medium-hard orange sponge pad to the plate, making sure it is correctly centred and firmly attached. Apply the product on the pad without exceeding. If you have a new pad, a greater amount of product must be used with respect to a used pad. In case of a used pad, make sure it is properly clean. Place the polisher cable on the shoulder to prevent any damage to the body. During the switch-on and switch-off phases it is recommended to place the polisher in contact with the surface to be treated, so as to prevent splashes of product on the body and/or on the operator. Polish the area of interest at minimum speed (800 Rpm), first proceeding horizontally, from right to left, treating a small portion at a time (60x40 cm). Once you have reached the opposite corner, move in the opposite direction, by moving the polisher downwards, so as to cover the previous section by 50%. Then proceed vertically, from bottom to top, along the entire area already treated, taking into account what is indicated above. Gradually increase the speed (up to 2000 Rpm) and treat the area again. It is important to proceed carefully by following the method described to spread the product, prepare the polish for action and obtain a uniform and even polish. After polishing the area, use a microfibre cloth and D2 Check to remove excess product and at the same time check the partial result of the polishing. Proceed to treat all areas you have chosen to polish. For the best finish, we recommend the use of P1 Polish Up. Precautions: Shake the product before use.
