This is for one 2hp module that can be configured in four different ways. It's a bit complicated to get your head around, but there are no electronics on this. It's just a means to connect various buses to jacks. 1) Bus outputs - In this mode you get all stereo outputs for all four buses. This mode is best for using as an extra set of outputs for Bartender or for connecting to a chain of Barbacks (no need for a Bartender). It's also a way to get 3.5mm output jacks for the CUE bus. 2) Bus outputs w/return (no cue) - This is similar to the first mode but you flip the panel over and use jumpers on the back to convert the CUE outputs in to a return. 3) Channel outputs (1-4) - This mode allows you to get unbalanced outputs for four stereo channels of either PRE or POST. 4) Channel outputs (5-8) - This is identical to the third mode, but you just flip the panel over to get markings for channels 5-8. ConnectionsFor modes 1 and 2 you'll want to connect both green PCBs, the jumpers go on the bottom half of the module. Then just set the jumpers to CUE or return and put the appropriate panel side in place. You'll then use the 2x8 cable to connect it to Expander output on Bartender or Barback. For modes 3 and 4 you'll want to just use the one green PCB with jacks on it. You'll then use the two 2x3 cables to connect to either the pre or post headers on one Bartender or two Barbacks. The panel for the channel outputs has two sides to support channels 1-4 or 5-8. You could also technically use this to output both pre and post for two channels, but there is no matching panel for that configuration. Note 1: Each 2hp module can only be configured for one mode at a time. If you want both bus outputs and channel outputs, you will need to purchase multiple units. Also if you want eight channels of direct outputs, you'll need to purchase multiple units. Note 2: These are all unbalanced outputs, so be mindful with both cable length and exposing the cables to noisy environments. Width: 2HP Depth: TBD Power: Passive
