Dual Air Gap for Water Softener and Reverse Osmosis with 5/8 or 1/2-inch and 3/8 or 1/4-inch inlets, 1-1/2 or 2-inch Standpipe (8500, GAP-CAP, AG130-001)

AquaShield Verified independent store

→

About This ♥ EASY TO CONNECT: Gap-Cap air gap (AG130-001) has 1/2-inch OD inlet port for 1/2-inch PVC pipe connection. The 1/2-inch inlet accommodates any 1/2-inch slip joint adapt ers including a threaded end, barb connection, and a quick connect for PEX tubing. The same inlet accommodates 5/8-inch OD tubing that can be directly inserted into the inlet. A 3/8-inch inlet port is provided for RO systems. This port can accommodate both 3/8-inch poly-tubing and 1/4-inch poly-tubing with included adapter. ♥ STANDPIPE CONNECTION: Gap-Cap air gap (AG130-001) inserts directly into the 1-1/2-inch and 2-inch standpipes. The body of the air gap provides stops to ensure secure placement. This air gap can be used with plastic or metal standpipes. If needed, it can be glued in place with plastic standpipes using regular PVC adhesive. The air gap outlet is designed to pass up to 7 gallons per minute. The optimum recommended flow rate is 4-5 gallons per minute. ♥ SPLASH PROTECTION: The AG130-001 air gap uses splash guards to assure a completely dry operation. Splash guards are an integral part of the design and can be seen through the side air gap window. During water softener operation, an initial discharge surge can create splashing. Splash shield eliminates the possibility of water splashing outside of the air gap. When designing drainage for an air gap, makes sure that P-trap is located minimum 20-inches from the top of the standpipe. ♥ QUIET OPERATION: When water exits the air gap, depending on the design, it may flow directly into a P-trap. This can create splashing noise that may be objectionable. To avoid excessive noise, it is recommended to use 22 degrees elbow inline with standpipe to avoid direct drainage to P-trap. The pipe elbow should be located at least 12 inches from the air gap to eliminate splashback. ♥ CERTIFICATION: The AG130-001 is legal to install in any state. It is UPC (Uniform Plumbing Code) Listed, IPC (International Plumbing Code) and NSF (National Sanitation Foundation) tested. These certifications assure that every product is safe to use. Also, all of the products are tested for strength and to make sure that every glue joint will withstand at least 40lb of force and not break. The testing is conducted for every manufactured lot to ensure consistent performance. Overview Size : 1/2 inch, 3/8 inch Material : Plastic Brand : AIR GAP INTERNATIONAL Color : White Item dimensions L x W x H : 4.25 x 2.25 x 2.25 inches Connector Type : Threaded-Barb-QuickConnect Thread Size : 2.25 inch Thread Type : NPT Item Weight : 0.1 Kilograms Number of Pieces : 1 Show more