The CZ rimfire rifles are some of the best. Real wood, machined steel, and classic lines make the 452/455/457 modern classics. BONUS: OUR RIMFIRE SIGHT WILL FIT MANY EUROPEAN RIFLES THAT UTILIZE 11mm RECEIVER GROOVES.Shown for example: Baikal MP94, Baikal MP221, Remington IZH 94 This sight will fit "SOME" air rifles and other nominally 11mm dovetails. Dovetails are difficult to measure and "sharp edge to sharp edge" measurements do not represent "slope to slope" dimensions. Manufactures specs vary also. Consequently, answering questions like, "Will your CZ RIMFIRE sight fit my HW80 air rifle?" is difficult. Best we can say is try it, if it doesn't fit perhaps, it can be fit with a little careful work, or we may have a larger size available. The SKINNER RIMFIRE sight is designed to be as simple and durable as possible with minimal bulk. My goal was to produce a sight that does NOT have protrusions, fragile clamps or require gunsmithing to install.Consequently, our securing system requires close tolerances. Fully adjustable for windage and elevation. Accepts all 5 Skinner Aperture sizes. Ships with a .096" aperture. Comes with the wrenches needed to install and adjust.MOUNTING A RECEIVER SIGHT ON ANY RIFLE WILL OFTEN REQUIRE A FRONT SIGHT CHANGE. PLEASE... READ THE INFORMATION ON OUR FAQ PAGE FOR ANSWERS ABOUT FRONT SIGHT SELECTION. "That's my Baikal double rifle 45-70 shown in the photo. Not only a fun gun to shoot, its accurate also! Pro Tip: On the Baikal rifles, sometimes the manufacture used the same front sight stems as the AK-47. That might help if a taller front sight is needed." Andy Mounting Instructions: Remove your existing barrel mounted rear sight (using a brass punch) and replace it with a dovetail blank. Ships with a .096" aperture installed. Accepts all 5 Skinner Aperture sizes. Wrenches for mounting and adjustment included. Loosen the rear "pinch" screw on the Skinner RIMFIRE sight and slide it carefully onto the top receiver "GROOVES" from the rear of the receiver. Set in the desired position and tighten the rear "pinch" screw enough to keep the sight from sliding. (Due to variables in receiver groove sizes, slight fitting may be required. No pounding to install. If fitting is needed, fit until the sight will slip on with firm thumb pressure. If there are questions, please give us a call @ 406-745-4570)
