A replacement battery LED for your Nintendo Game Boy DMG, Game Boy Color, or Game Boy Pocket. Included resistor for better compatibility. LED plastic is slightly opaque in nature. This will help diffuse the light for fully illuminated LED. FEATURES: 3K ohm resistor included to reduce brightness (For DMG). Simply replace the old LED with a new one for the GBP. Use a 3K or even 4K ohm resistor to reduce even more if you desire (DMG). Use these LEDs for cases as well. Compatible with the DMG, GBC, and GBP. Rainbow LED. See it in action here. Solder Wick will help for an easier install. INCLUDED: 1x LED 1x 3K ohm resistor PAIRS WELL WITH: Game Boy Macro Dowel Rod DOCUMENTATION: Open your Game Boy by removing the 6 tri-wing screws on the back panel. Also remove the Phillips head screws connecting the front PCB to the front shell. Separate the two units and locate the LED. Use a solder wick to remove the solder around the led leads. Remove the LED. For DMG you will need to replace the "R1" resistor located near the top of the PCB. Use your soldering wick again to remove the excess solder on the front of the PCB. Replace this resistor with a 2K-3K ohm resistor to reduce the brightness of the LED. Otherwise, it would be much too bright. Solder in the LED (short leg is the negative side, and the long side is the positive) and the resistor in place. NOTES: LED may be a clear white upon arrival. It will show the chosen color once installed. You can use a multimeter to test the LED color before install. These LEDs can be used for a variety of game consoles such as N64 and GameCube as well. However, the size may be smaller than the original.
Related
Related
Related
Related