General Strength, life and reliability rating for nominal load and load spectrum Database for reference profile and tolerances Different geometry configurations with uniform tooth depth, constant slot width, modified slot width, different root and tip apex positions For spur, helical, zerol or spiral bevel gears Rough and fine sizing function, fine sizing function for modifications Calculation of measurement grid for Klingelnberg, Gleason or Zeiss gear tester Strength rating Strength rating along ISO 10300, DIN 3991, AGMA 2003, KN3028 / KN3030 for Cyclo-Palloid gears and along KN3025 / KN3030 for Palloid gears Hypoid gear calculation along KN3029 / KN3030 for Cyclo-Palloid gears, KN3026 for Palloid gears, ISO 10300 Plastic gear rating along VDI 2545 or Niemann, static strength rating and rating of differential planetary gears Efficiency along Wech, Niemann, ISO/TS 1300-20 Flank breakage calculation along ISO/DTS 10300-4 Scuffing rating along DIN 3990-4, ISO/TS 6336-20, ISO/TS 6336-21, ISO/TS 10300-21 Manufacturing For face hobbed or face milled gears Considering Klingelnberg machine list Accurate 3D gear geometry for CNC machining, based on planar involute geometry No load tooth contact analysis considering lead and profile modifications No load tooth contact Calculated of loaded tooth contact with low load Considers all gear modifications Direct input of misalignment values For verification of contact patterns after manufacturing Loaded tooth contact analysis LTCA of spur, helical and spiral bevel gears For nominal load or with consideration of KA and Kv and for load spectrum Using slice model Line load distribution over whole face width (contact pattern under load) Momentary line load distribution as contact lines for different mesh positions Bevel gear transmission error Loaded or non-loaded (lightly loaded) TE PPTE values FFT of transmission error Further load distribution-based results Flash and contact temperature Scuffing safety factor Flank fracture safety factor Micropitting (adapted from cylindrical gear calculation) Contact for misaligned systems Input of HGV misalignment Input of shaft angle deviation For drive and coast side Considering housing, bearing and shaft deformation Tooth flank fracture calculation Calculated hardness distribution Hardness distribution input from measurements Calculation along ISO/DTS 6336-4 and Annast Differential gears Fine sizing of differential gears LTCA for spur gears with modifications
Related
Related
Related
Related