Under hard acceleration, the pendulum mount (commonly referred to as the "dogbone" or by VW as the "torque arm") acts to limit rotational movement of the engine - The factory bushings do a satisfactory job, while limiting vibrations, but only during sedate driving conditions. When pushed hard those bushings flex creating a vague feeling in the engine and gearbox, and adding to the dreaded "wheel hop" phenomenon. Our pendulum mount torque arm insert fills the voids in the stock rubber bushing, making what was a soft rubber bushing with voids into what behaves like a solid mount. With the insert installed, you will notice that throttle response will feel better and your shifts will feel more crisp and defined, especially on manual transmission cars. Designed In-house, these mounts are made to be the stiffest on the market made from the highest quality (90a) durometer polyurethane. Each insert is pressure injection molded to insure a consistent hardness throughout the mount for long life even under hard driving conditions. KIT INCLUDES: One torque arm / dogbone insert Installation hardware and washers FITS: All 2005.5-2008 vehicles including Golf/GTI, Jetta/GLI, Tiguan and Passat, as well as, MK2 Audi TT and 8P A3. SPECIAL NOTE: You may experience some in-cabin vibrations after installing our insert. These vibrations are most noticeable in reverse and while the a/c is engaged at idle. These are normal and will subdue after approximately 1,000 miles of driving. TDI models will experiencing increased NVH compared to gasoline vehicles due to the design of the diesel engine. Untitled Document
