From our Bulletproof Custom saw performance shop, this saw is hand assembled in America. The BP660 is built to meet your needs from large diameter firewood and milling to commercial tree professionals. We build these saws at our full time saw shop, inspecting every single part during assembly. Our saws have a proven track record over the years and are NOT the same as the saws you might find built by a kid on college break in his moms basement. We stand behind our saws and have a parts stock on hand for when the ground crew accidentally crushes the saw with the truck or loader. With over a decade of experience building performance saws for milling and production logging crews we have developed a build that is not only economical but also worthy of the name Bulletproof! We start with an aftermarket farmertec parts kit, with each component inspecfed and tested against our rigorous standards. We use a high quality Hyway Big Bore Pop-Up Piston and Cylinder set for the top end (Ask us about Meteor if that interest you) We replace both the wrist pin bearing and clutch bearing with Hyway components, we have had an almost zero failure rate since switching, We install a High Output oiler to handle the longer bars used for milling Upgraded foam filter with extra filter and foam filter oil. Filter in saw comes oiled and ready to run. Finally we install a Hyway Heavy Duty handle, which will withstand the abuse these saws deserve or swap to the 3/4 wrap handle. Your choice. Each saw is started and tested then tuned in wood. We start the break in process to identify any problem components before we ship the saw. Additional custom builds available upon request for an additional cost. **Free shipping valid for the lower 48 states ** Bars and chains that are pictured are not included but can be purchased for an additional cost. ***These saws are clone saw parts kits, Lead time is variable and usually 1-2 weeks, please feel free to contact us before your purchase for a better estimate of lead time.
