This product is designed to work with any Autobeam LED headlight or fog light unit. Information Many existing vehicles are designed for use with halogen-based products, and installing LEDs can often trigger a warning light on your car's dashboard. LED technology uses a lower wattage, and the vehicle believes the LED bulb is faulty. The Autobeam canbus control unit for LED lamps eliminates this problem. Installation of this item bypasses the lamp failure function of the can-bus system on your vehicle. It's easy to install onto the car - Plug one side into the bulb and the other side into the factory plug. Using this product doesn't negatively impact the light output or heat management of the LED lamps. Installation Install the Autobeam LED bulbs, If any errors or flickering occurs then proceed to using this product. If the control unit does not fit in the headlight it may need mounted externally; Drill a 20mm hole in the headlight cap, feed the cables through and click the grommet into place. Plug the LED bulb cable in ensuring the + and - is matching. it's important this is plugged in the correct way. Plug the other canbus cable into the factory bulb holder, its also important for this to be plugged in the correct way however the factory connector often isn't labeled. Turn the lights on and test that they illuminate, if they don't rotate the plug 180 degrees and try again. Check the errors or flickering are no longer active, if the same issues still occur plug in the additional cable in and connect to the battery; Red to + and Black to -. What's in the box 2x Canbus control units1x Battery cable (Often not required) Warranty 12 Months Other Information Packaging type may vary depending on stock. If you are having any issues with your LED conversion(s) such as the below then this is the product for you: CANBUS Dash Error/Warning - Most European cars are fitted with CANBUS systems, which warn you of bulb errors. One Bulb Out - One side of the bulb is not functioning correctly.
