Engine Control Module for Toyota CamryThis remanufactured Cardone Engine Control Module is built for precise electronic control and direct OE-style fitment. It is engineered for the 1997 Toyota Camry with California Emission System and USA-built configuration, using the correct aluminum housing and connector layout for the application.Cardone Part Number 72-11321 is remanufactured to restore dependable engine management performance on the 1997 Toyota Camry. This ECM is a direct replacement for OE number 89661-06380 and is designed for vehicles that require immobilizer reset procedures after installation.Key Features Remanufactured Original Equipment-style engine control module Fits 1997 Toyota Camry, with California Emission System; USA Built Direct replacement for OE number 89661-06380 Aluminum housing for OE-style construction 3 connector design with rectangular connector shape 26;16;22 terminal layout with male pin terminals 100% computer tested for functionality Critical components are re-soldered or replaced during remanufacturing Flash programming required: No Flashable: No Product DetailsCardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are rebuilt to address common failure points found in original modules. For this Cardone 72-11321 ECM, the remanufacturing process includes inspection of the original design, correction of known weaknesses, and replacement or re-soldering of critical internal components at the Philadelphia manufacturing plant. The result is a direct-fit module for the Toyota Camry that supports stable engine control without requiring flash programming.This part cross-references Toyota OE number 8966106380 for the same application.Common Problems This ECM Can Address No-start condition related to a failed engine control module Intermittent stalling or loss of engine management signals Check engine light caused by internal ECM failure Driveability issues tied to corrupted or damaged control electronics Communication faults caused by a defective original module Installation Notes and Tips Fits 1997 Toyota Camry, with California Emission System; USA Built; with OE # 89661-06380. Immobilizer reset is required; refer to the service manual for the correct procedure. Before replacing the original ECM, verify power, ground, wiring harness condition, and related relays or solenoids. Confirm the OE engineering number and connector layout match the original unit before installation. Do not assume the original ECM is the only fault source; diagnose the vehicle first to avoid repeat failure. Quality AssuranceEach Cardone remanufactured ECM is computer tested to verify operation before release. The remanufacturing process is designed to recover OE-level fit and function while reducing the raw material and energy required to produce a new part.
