Remanufactured ECM for Toyota CamryThis Cardone remanufactured Engine Control Module is built for precise OE-style fit and reliable engine management. It is a direct replacement for the 1996 Toyota Camry with Federal Emission System and OE number 89661-33740, making it a focused solution for a specific factory application.Cardone remanufactured electronic and powertrain control modules are reverse-engineered to identify common failure points, then critical components are re-soldered or replaced at the Philadelphia manufacturing plant. Each unit is computer tested for function and durability before release.Key Features Remanufactured Original Equipment-style Engine Control Module Fits 1996 Toyota Camry, N/A, with Federal Emission System Direct replacement for OE number 89661-33740 3 rectangular connectors with blade-style male terminals Aluminum housing for factory-style mounting and protection Computer tested for reliability and performance Reverse-engineered remanufacturing process addresses original design weaknesses Earth-friendly remanufacturing reduces raw material and energy use versus new part production Detailed DescriptionThe Cardone 72-1576 ECM is a remanufactured control module for the 1996 Toyota Camry, engineered for the Federal Emission System application. It is pre-programmed at the factory for the listed fitment and uses three rectangular connectors with 26, 16, and 12 blade terminals. This part cross-references Toyota 8966106270 and 8966133740 for the same application.As part of Cardone’s Engine Control Module line, this unit is remanufactured to restore factory-level electronic control after the original module has failed. The process includes re-soldering or replacing critical internal components, then validating the module through computer testing or bench testing depending on application.Common Problems This ECM Can Address No-start condition caused by a failed engine control module Intermittent stalling or rough running tied to ECM failure Check engine light concerns related to module malfunction Loss of fuel, ignition, or emissions control commands from the ECM Driveability issues after confirming power, ground, and wiring integrity Installation Notes and TipsBefore replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, poor power supply, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number on the original module matches the listed application before installation.For this 1996 Toyota Camry ECM, factory programming is already applied for the listed application. No flash programming is required. Use an OE-approved service manual and inspect connectors, terminals, and harness condition before final installation.Quality AssuranceCardone remanufactured control modules are tested to meet or exceed OE performance expectations. Each unit is validated for function, and the remanufacturing process is designed to correct known failure points while supporting dependable vehicle operation.
