Remanufactured ECM for Nissan MaximaCardone 72-30825F is a remanufactured engine control module built for precise electronic control and OE-style fitment. It is listed for the 2005 Nissan Maxima with traction control and requires vehicle-specific on-car programming after installation, along with an anti-theft relearn procedure.Key Features Remanufactured Original Equipment-style engine control module Fits the 2005 Nissan Maxima, N/A, with traction control Aluminum housing with 1 rectangle connector and 111 male pin terminals Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability Flash programming required: No Flashable: No Product DetailsCardone’s Engine Control Module line focuses on restoring factory-level electronic performance through remanufacturing rather than rebuilding from scratch. For this application, the 72-30825F is engineered for the 2005 Nissan Maxima and cross-references Nissan part numbers 237107Y210 and A56X51ZZ5 for the same application. The module is designed to address original design weaknesses identified through reverse engineering, with critical electrical points reworked at Cardone’s Philadelphia manufacturing plant. This part number, 72-30825F, is intended for vehicles that match the listed ID number and configuration.Common Issues This ECM May Resolve No-start or hard-start conditions after ECM failure Drivability problems tied to incorrect engine management signals Intermittent electrical faults caused by damaged internal solder joints Fault codes related to control module malfunction Starting issues after replacing a failed original module Installation Notes and TipsBefore replacing the original ECM, verify the root cause of the failure, including grounds, power supply, wiring harness condition, and shorted solenoids or relays. For the 2005 Nissan Maxima, vehicle-specific on-car programming must be performed after installation to prevent drivability and starting issues, and the anti-theft relearn procedure is required. Confirm the module ID number matches the application before installing Cardone 72-30825F.Quality AssuranceEach Cardone Engine Control Module is computer tested, and the remanufacturing process includes re-soldering or replacement of critical components to improve electrical integrity. The process also reduces raw material and energy use compared with manufacturing a new part, while maintaining OE-style fitment and performance targets.
