Cardone Engine Control Module for Taurus and SableRestore engine management performance with the Cardone 78-1036F remanufactured Engine Control Module. This ECM is built for 2004-2005 Ford Taurus and 2004-2005 Mercury Sable applications with Module ID HBO-425, and it requires vehicle-specific flash programming after installation.Cardone remanufactured electronic and powertrain control modules are engineered to meet or exceed original equipment performance. Each unit is computer tested, and critical internal components are re-soldered or replaced during remanufacturing at Cardone’s Philadelphia facility.Key Features Fits 2004-2005 Ford Taurus, N/A, with Module ID HBO-425 Fits 2004-2005 Mercury Sable, N/A, with Module ID HBO-425 Remanufactured Original Equipment-style ECM for direct vehicle fit Vehicle-specific flash programming required on or off the vehicle Accurate VIN and mileage information required for programming PATS module programming required after ECM installation Computer tested for functionality and reliability Critical components re-soldered or replaced during remanufacturing Product DetailsThe Cardone 78-1036F Engine Control Module is a remanufactured replacement for select Ford Taurus and Mercury Sable models. It is built to address common control-module failures by using reverse engineering to identify original design weaknesses and correct them during the remanufacturing process. This part cross-references Ford OE numbers such as 4F1A12A650RA and 4F1Z12A650RA for the same application.For 2004-2005 Ford Taurus and 2004-2005 Mercury Sable vehicles, correct VIN and OE number verification are important before ordering. The module must be programmed after installation to prevent drivability and starting concerns, and the PATS system requires programming as part of the repair process.Common Issues This ECM May Resolve No-start or hard-start conditions after ECM failure Drivability problems caused by a faulty engine control module Communication or calibration issues related to the original PCM/ECM Intermittent electrical faults from damaged internal module connections Problems caused by failed original module solder joints or components Installation NotesBefore replacing the original ECM/PCM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford engineering ID on the original module matches the correct Cardone application before installation.After installation, perform the required flash programming using the correct VIN and mileage data. On these applications, vehicle-specific on-car programming must be completed to avoid starting and drivability issues. PATS programming is also required after ECM replacement.Quality AssuranceCardone remanufactured control modules are computer tested and validated for durability and performance. The remanufacturing process also reduces raw material and energy use compared with producing a new part, while restoring the module to OE-level function for the intended Ford Taurus and Mercury Sable applications.
