Remanufactured ECM for 1999 Dodge Ram 1500Cardone 79-0028V is a remanufactured engine control module for the 1999 Dodge Ram 1500 with Federal Emission System. It is built for direct OE-style fitment and requires vehicle-specific flash programming with accurate VIN and mileage information.Key Features Remanufactured Original Equipment-style engine control module Three rectangle connectors with 32-pin male terminals per connector Aluminum housing for OE-style mounting and durability Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability On-car validation is used to verify durability and performance Earth-friendly remanufacturing process reduces raw material and energy use versus new part production Product DetailsCardone’s Engine Control Module line focuses on restoring factory-level electronic control performance through reverse engineering, component-level repair, and testing. For this application, the 79-0028V is the correct remanufactured ECM for a 1999 Dodge Ram 1500 with Federal Emission System and OE number coverage from 5604 0028AA through AG. This part cross-references Dodge OE numbers 56030028AA and 56040028AA for the same application.What This ECM Can Help Resolve No-start or hard-start conditions caused by a failed engine control module Driveability problems tied to incorrect fuel or ignition control Communication faults related to ECM internal failure Intermittent electrical issues caused by damaged solder joints or internal circuitry Check engine light concerns traced to module malfunction Installation NotesFits 1999 Dodge Ram 1500, N/A. Vehicle-specific flash programming is required on or off the vehicle, and accurate VIN and mileage are required. Before replacing the original ECM, verify power, grounds, wiring harness condition, and related relays or solenoids to avoid repeating the original failure. Confirm the OE number on the original module matches the listed interchange before installation.Quality AssuranceEach Cardone remanufactured ECM is computer tested, and application-specific units may also be bench-tested or validated on the vehicle. Re-soldering or replacement of critical components is used to improve electrical integrity and long-term reliability.
