Cardone ECM for 2002 Dodge Ram 1500Cardone Engine Control Module 79-0203V is a remanufactured ECM built for the 2002 Dodge Ram 1500 with Federal Emission System. It is a direct-fit electronic control module for vehicles that require flash programming and VIN-specific setup.Key Features Remanufactured Original Equipment-style engine control module for accurate fitment Fits 2002 Dodge Ram 1500, N/A, with Federal Emission System Flash programming required; accurate VIN and mileage data are required for setup Three rectangle connectors with 32-pin male terminals Aluminum housing for OE-style mounting and durability Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability Earth-conscious remanufacturing process reduces raw material and energy use versus new part production Product DetailsCardone 79-0203V is part of the Cardone Engine Control Module line, which focuses on remanufactured electronic and powertrain control units. For this application, the module is engineered to restore factory-style engine management on the 2002 Dodge Ram 1500 and cross-references Dodge OE numbers 56040203AA through 56040203AG. This part cross-references Dodge OE numbers 56040203AA and 56040203AG for the same application.The module is remanufactured from an original equipment core, then inspected, repaired, and computer tested to verify operation before release. Cardone also uses reverse engineering to identify common failure points and correct design weaknesses found in the original unit.What It Can Help Fix No-start or hard-start conditions related to ECM failure Check engine light concerns caused by control module faults Driveability problems tied to incorrect fuel or ignition control Communication or powertrain management issues after module failure Intermittent electrical faults caused by damaged internal solder joints Installation Notes Verify the original ECM/PCM failed before replacement; check grounds, power feeds, wiring harness condition, and related relays or solenoids. Flash programming is required for this application, and accurate VIN and mileage information must be provided. Use the OE-approved service procedure for programming and initialization. Confirm the OE number on the original module matches the Cardone cross-reference before installation. Quality AssuranceCardone remanufactures this ECM to meet or exceed OE performance expectations. Each unit is computer tested, and critical internal connections are reworked to improve electrical integrity and long-term reliability. The remanufacturing process also reduces energy and raw material use compared with producing a new module.
