Remanufactured ECM for Dodge Ram 1500-3500The Cardone 79-0410V Engine Control Module is a remanufactured ECM built for 2000 Dodge Ram 1500, Ram 2500, and Ram 3500 applications with Federal Emission System calibration. It is designed for vehicle-specific flash programming and accurate VIN and mileage input during setup.Key Features Remanufactured original equipment-style engine control module for a precise vehicle fit Three rectangular connectors with 32-pin male terminals per connector Aluminum housing for OE-style mounting and durability Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability On-car validation is used to confirm durability and performance by application Earth-conscious remanufacturing reduces raw material and energy use versus building a new part Product DetailsCardone Engine Control Module 79-0410V is part of the brand’s remanufactured electronic and powertrain control module line. Cardone reverse engineers failed units to identify common design weaknesses, then corrects those issues during the remanufacturing process. For 2000 Dodge Ram 1500, Ram 2500, and Ram 3500 trucks, this ECM is listed with OE cross-reference coverage for Dodge applications and requires flash programming before use.This part cross-references Dodge OE numbers such as 56040410AB and 56040410AG for the same application.Common Problems This ECM Can Address Engine no-start caused by a failed control module Intermittent drivability issues tied to internal ECM faults Communication problems related to damaged module circuitry Calibration or programming issues after ECM replacement Failure from heat- or vibration-related solder joint damage Installation Notes Fits 2000 Dodge Ram 1500, N/A, with Federal Emission System and OE # 5604 0410AB-AG. Fits 2000 Dodge Ram 2500, N/A, with Federal Emission System and OE # 5604 0410AB-AG. Fits 2000 Dodge Ram 3500, N/A, with Federal Emission System and OE # 5604 0410AB-AG. Vehicle-specific flash programming is required on or off the vehicle. Accurate VIN and mileage are required during programming. Verify the original failure cause before replacing the ECM; check grounds, power feeds, wiring harness condition, and related solenoids or relays. Confirm the OE number and connector layout before installation. Quality AssuranceEach Cardone remanufactured ECM is computer tested, and application-specific units are bench-tested or validated on vehicle as part of the remanufacturing process. The 79-0410V is built to meet or exceed OE performance expectations for the listed Dodge Ram applications.
