Remanufactured ECM for Chrysler ApplicationsCardone 79-1007 is a remanufactured Engine Control Module built to restore factory-style engine management performance. It is a direct-fit electronic control module with a rectangle connector, 10 male pin terminals, and a plastic housing for the 1977 Chrysler LeBaron spark control application.Compatible With 1977 Chrysler LeBaron, N/A, this Cardone Engine Control Module is pre-programmed at the factory for the listed application. The Cardone 79-1007 is also referenced for Chrysler and Dodge OE numbers 4091946 and 4106057.Key Features Remanufactured ECM for OE-style fit and function Fits 1977 Chrysler LeBaron spark control applications Rectangle connector design with 10 pin male terminals Plastic housing construction No flash programming required No removable PROM 100% computer tested for functionality Critical components are re-soldered or replaced during remanufacturing Product DetailsCardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are rebuilt to meet or exceed original equipment performance. For this application, the module is reverse engineered to identify common failure points, then corrected through component-level repair at Cardone’s Philadelphia manufacturing plant. The result is a remanufactured ECM that supports reliable engine control in the 1977 Chrysler LeBaron and related OE-numbered applications.This part cross-references Chrysler and Dodge OE numbers 4091946 and 4106057 for the same application. Search terms such as 1977 Chrysler LeBaron ECM replacement, Cardone 79-1007 engine control module, and pre-programmed Chrysler spark control module all point to this direct-fit unit.What This ECM Can Help Resolve No-start or hard-start conditions tied to a failed control module Intermittent engine control issues caused by internal electronic faults Driveability problems related to incorrect spark control output Failure codes traced to the original ECM Problems caused by worn solder joints or damaged internal components Installation NotesBefore replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford, Chrysler, or GM programming requirements only when the vehicle platform calls for them; for this Chrysler application, the module is pre-programmed at the factory. Match the OE number on the original unit to the Cardone reference before installation.Quality AssuranceEach Cardone remanufactured control module is computer tested, and application-specific validation is used to confirm durability and performance. The remanufacturing process also reduces the energy and raw material needed to produce a new part by up to 80%, supporting a lower-waste repair choice. E-waste designation applies to this module.
