Remanufactured ECM for Jeep CherokeeCardone 79-1480V is a remanufactured engine control module built for 1999 Jeep Cherokee applications with Federal Emission System. It is engineered to restore factory-style engine management, flash programming, and drivability control for the correct OE-style replacement.Compatible with 1999 Jeep Cherokee, this Cardone engine control module is identified by part number 79-1480V and is intended for vehicles requiring vehicle-specific flash programming after installation.Key Features Remanufactured Original Equipment-style ECM for a precise vehicle fit Three rectangle connectors with 32-pin male terminals per connector Aluminum housing for OE-style module construction Critical components are re-soldered or replaced during remanufacturing Computer tested for functionality and reliability On-car validation is used to verify durability and performance Earth-friendly remanufacturing process reduces raw material and energy use versus new part production Product DetailsCardone’s Engine Control Module line focuses on restoring electronic and powertrain control performance through remanufacturing and testing. For this application, the 79-1480V ECM is built for 1999 Jeep Cherokee models with Federal Emission System and OE number 5604 1480AA through AE. Flash programming is required, and accurate VIN and mileage information are needed for proper setup. This module is a direct-fit replacement for the original control unit when the vehicle calls for this specific calibration and programming process.This part cross-references Jeep OE numbers 56041480AA and 56041480AB for the same application.Common Problems This ECM Can Address Engine no-start conditions caused by a failed control module Drivability issues related to incorrect fuel and ignition control Communication faults tied to internal ECM failure Intermittent stalling or rough running from damaged module circuitry Check engine light concerns linked to ECM malfunction Installation Notes Fits 1999 Jeep Cherokee, N/A, with Federal Emission System. Vehicle-specific flash programming must be performed after installation to prevent drivability and starting issues. Accurate VIN and mileage are required for programming. On-car programming is required after installation. Before replacing the original ECM, verify power, grounds, wiring harness condition, and related solenoids or relays. Confirm the OE number and module identification match the application before installation. Quality AssuranceEach Cardone remanufactured ECM is computer tested, and critical internal components are reworked to address common failure points found during reverse engineering. The remanufacturing process is performed at Cardone’s Philadelphia manufacturing plant with attention to OE-level performance and fit.
