Remanufactured ECM for Neon ApplicationsCardone 79-3063V is a remanufactured engine control module built for 1998-1999 Dodge Neon and 1998-1999 Plymouth Neon applications with Federal Emission System. It is engineered to restore proper engine management with OE-style fitment and vehicle-specific flash programming requirements.Key Features Remanufactured Original Equipment-style engine control module Fits applications with 2 rectangle connectors and 40-pin male terminals Aluminum housing for OE-style mounting and durability Critical components are re-soldered or replaced during remanufacturing 100% computer tested for functionality and reliability Flash programming required for vehicle-specific calibration Compatible with 1998-1999 Dodge Neon and 1998-1999 Plymouth Neon, N/A position Product DetailsCardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are reverse engineered to identify common failure points and correct original design weaknesses. For this application, part number 79-3063V is built to meet or exceed OE performance expectations and is validated through automated testing and on-car vehicle validation where required. This part cross-references Chrysler 5293063AA and 5293063AF for the same application.Common Problems This ECM Can Address Engine no-start or intermittent start conditions related to ECM failure Driveability issues caused by incorrect fuel or ignition control Check engine light concerns tied to module malfunction Communication or calibration problems after ECM replacement Failure caused by internal solder joint or component breakdown Installation Notes Fits 1998-1999 Dodge Neon, N/A, with Federal Emission System and OE numbers 5293 063AA-AF or 5293 148AA. Fits 1998-1999 Plymouth Neon, N/A, with Federal Emission System and OE numbers 5293 063AA-AF or 5293 148AA. Vehicle-specific flash programming is required on or off the vehicle. Accurate VIN and mileage information are required for programming. Before replacing the original ECM, verify powers, grounds, wiring integrity, and related relays or solenoids. Chrysler PCM units identified with a “V” suffix require VIN programming. Quality AssuranceEach Cardone remanufactured control module is processed at the Philadelphia manufacturing plant, where critical electrical components are reworked and the unit is computer tested before release. The remanufacturing process also reduces raw material and energy use compared with producing a new part, while maintaining OE-style performance targets for this ECM.
