Remanufactured ECM for Jeep CommanderCardone 79-4325V is a remanufactured engine control module built for 2006 Jeep Commander applications with the listed OE numbers. It is engineered to restore factory-style engine management performance for Jeep Commander vehicles that require flash programming and VIN-specific setup.Key Features Remanufactured Original Equipment-style engine control module for a precise vehicle fit 3 rectangle connectors with 38 pin male terminals per connector Aluminum housing for OE-style module construction Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability On-car validation used to verify durability and performance Earth-friendly remanufacturing process reduces raw material and energy use versus new part production Product DetailsCardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control modules that are returned to service after inspection, repair, and testing. For this application, the module is built to meet OE performance expectations and is intended for 2006 Jeep Commander models listed with OE references 5094 325ZF and 5094 325AA through AJ. Part number 79-4325V is a direct-fit style replacement for the specified Jeep Commander engine control module application.This part cross-references Jeep OE numbers 5094325AA and 5094325ZF for the same application.What This ECM Helps Address Engine no-start or hard-start conditions tied to a failed control module Check engine light concerns caused by internal ECM faults Communication or drivability issues related to module failure Intermittent electrical operation from damaged solder joints or internal components Problems traced to a worn or failed original engine control module Installation Notes Fits 2006 Jeep Commander, N/A, with OE # 5094 325ZF; vehicle-specific flash programming required on or off the vehicle. Fits 2006 Jeep Commander, N/A, with OE # 5094 325AA thru AJ; vehicle-specific flash programming required on or off the vehicle. Accurate VIN and mileage are required for programming. Flash programming is required before the vehicle is returned to service. Before replacing the ECM, verify power, ground, wiring harness condition, and related solenoids or relays to confirm the original module is the failed component. Chrysler PCM units identified with a “V” suffix require VIN programming. Quality AssuranceEach Cardone remanufactured ECM is computer tested, and the remanufacturing process includes re-soldering or replacement of critical internal components at Cardone’s Philadelphia manufacturing plant. The module is also validated on vehicle for durability and performance, helping support reliable operation in the 2006 Jeep Commander application.
