Engine Control Module for Chrysler, Dodge, and PlymouthThe Cardone 79-6886 remanufactured Engine Control Module is built for direct replacement in select 1995 Chrysler Spirit, Dodge Spirit, and Plymouth Acclaim applications. It is remanufactured to meet or exceed original equipment performance, with critical components re-soldered or replaced and each unit computer tested for reliability.Key Features Remanufactured Original Equipment-style ECM for a precise vehicle fit 1 rectangular connector with 60 pin male terminals Plastic housing with 2 mounting holes No flash programming required and not flashable Pre-programmed at the factory for listed applications Reverse-engineered remanufacturing process addresses common failure points On-car validation and automated testing used to confirm durability and function Earth-friendly remanufacturing reduces raw material and energy use versus new part production Product DetailsCardone Engine Control Module 79-6886 is a remanufactured ECM designed for direct OE-style replacement in 1995 Chrysler Spirit, 1995 Dodge Spirit, and 1995 Plymouth Acclaim vehicles. This module is built from original equipment cores and restored at Cardone’s Philadelphia manufacturing plant, where critical electrical connections are re-soldered or replaced to help correct common internal weaknesses. The result is a replacement engine control module that supports proper engine management and factory-style operation for the listed fitments. This part cross-references Dodge 4686886 and Plymouth 4686886 for the same application.What This ECM Helps Address No-start or hard-start conditions related to a failed engine control module Intermittent drivability issues caused by internal ECM electrical faults Check engine concerns tied to control module failure Communication or powertrain control problems after module deterioration Replacement needs for a damaged or non-functioning factory ECM Installation NotesBefore replacing the original ECM, verify that power, grounds, wiring harness condition, and related relays or solenoids are not the root cause of the failure. For Chrysler PCM applications, modules identified with a “V” suffix require VIN programming; confirm the exact service requirement for your vehicle before installation. This unit is pre-programmed at the factory for the listed applications, and fitment should be matched carefully to the original engineering number and vehicle configuration.Compatible With 1995 Chrysler Spirit, 1995 Dodge Spirit, and 1995 Plymouth Acclaim. Use the original module identification and vehicle service information to confirm the correct replacement before installation.Quality AssuranceCardone remanufactured electronic and powertrain control modules are reverse-engineered to identify original failure causes, then restored with re-soldered or replaced critical components. Each unit is computer tested, and some applications also receive bench testing or on-car validation to confirm function and durability.
