Remanufactured ECM for Chrysler and DodgeCardone Engine Control Module 79-6907V is a remanufactured engine control module built for specific Chrysler and Dodge applications. It is designed for 2003-2004 Chrysler 300M, Concorde, and Intrepid, plus 2003-2004 Dodge Intrepid models with matching OE numbers and required flash programming.This Cardone Engine Control Module line focuses on restoring factory-level electronic control with remanufactured OE fit and application-specific testing. The 79-6907V part number is a direct reference for buyers searching for a Chrysler PCM or ECM replacement that requires VIN-based programming.Key Features Remanufactured Original Equipment-style engine control module Fits applications with 4 rectangular connectors Aluminum housing with 3 mounting holes 38-pin male terminals on each connector Flash programming required for vehicle-specific setup Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability On-car validation used to confirm durability and performance Detailed DescriptionCardone 79-6907V is a remanufactured ECM for Chrysler and Dodge vehicles that use OE part numbers 4606907AA through 4606907AF and 4896507AB through 4896507AE. It is built to meet OE performance expectations and is tested after remanufacturing to verify operation. This part is a strong search match for drivers needing a 2003-2004 Chrysler 300M ECM, 2003-2004 Chrysler Concorde PCM, or 2003-2004 Dodge Intrepid engine control module.Because this unit requires flash programming, accurate VIN and mileage information are needed during setup. Chrysler PCM units identified with a “V” suffix require VIN programming. If you are replacing the original module, verify the OE engineering number and confirm the original failure source before installation.This part cross-references OE numbers 4606907AA and 4896507AB for the same application.What This ECM Helps Address No-start or hard-start conditions tied to a failed engine control module Check engine light concerns caused by internal ECM faults Communication or drivability issues related to powertrain control failure Intermittent electrical operation from damaged internal solder joints Replacement needs after module failure on Chrysler 300M, Concorde, Intrepid, or Dodge Intrepid Installation Notes and Tips Fits 2003-2004 Chrysler 300M, N/A Fits 2003-2004 Chrysler Concorde, N/A Fits 2003-2004 Chrysler Intrepid, N/A Fits 2003-2004 Dodge Intrepid, N/A Confirm the OE number on the original module before ordering Flash programming is required; use accurate VIN and mileage data Inspect grounds, wiring, relays, and solenoids before replacing the ECM Some Ford and GM anti-theft reset procedures are application-specific, but this Chrysler/Dodge module is identified by VIN programming requirements Quality AssuranceCardone remanufactures this engine control module by reverse engineering failed units to identify original design weaknesses, then re-soldering or replacing critical components at its Philadelphia manufacturing plant. Each module is computer tested, and application validation is used to confirm performance before release.E-waste reduction is part of the remanufacturing process, helping reduce raw material and energy use versus producing a new part.
