Engine Control Module for Chrysler, Dodge, and PlymouthRestore engine management performance with this remanufactured Cardone Engine Control Module, part number 79-7169. It is built for direct replacement in select 1996 Chrysler Town & Country, Chrysler Voyager, Dodge Caravan, and Plymouth Voyager applications with matching OE numbers.Cardone remanufactured electronic and powertrain control modules are engineered to address common failure points found in original units. This ECM is pre-programmed at the factory for the listed applications and is designed for a precise fit in vehicles using the correct connector layout and calibration.Key Features Remanufactured original equipment-style engine control module Fits applications with 2 rectangular connectors Aluminum housing for OE-style mounting and durability 40-pin male terminal design Factory pre-programmed for listed 1996 applications Computer tested for function and reliability Critical components re-soldered or replaced during remanufacturing Flash programming required: No Flashable: No Detailed DescriptionCardone 79-7169 is a remanufactured Engine Control Module (ECM) for select Chrysler, Dodge, and Plymouth minivans. It is listed for 1996 Chrysler Town & Country, 1996 Chrysler Voyager, 1996 Dodge Caravan, and 1996 Plymouth Voyager with OE references 4727122, 4727169, and 4883268. This part cross-references Chrysler OE numbers 4727122 and 4727169 for the same application.The Cardone Engine Control Module line focuses on correcting common weaknesses found in original control units. Each module is reverse-engineered, then critical electrical components are re-soldered or replaced at Cardone’s Philadelphia manufacturing plant. The result is a remanufactured ECM that is validated for durability and performance before it leaves the facility.What This ECM Helps Resolve No-start or intermittent start conditions tied to a failed engine computer Driveability problems caused by corrupted or failing control logic Communication issues related to a damaged ECM Check engine concerns traced to internal module failure Electrical faults caused by worn solder joints or internal component breakdown Installation Notes and TipsBefore replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. For Chrysler PCM units identified with a “V” suffix, VIN programming is required. Confirm the OE number on the original module matches the listed interchange before installation.Compatible with 1996 Chrysler Town & Country, 1996 Chrysler Voyager, 1996 Dodge Caravan, and 1996 Plymouth Voyager when the OE number matches the listed references. This part is pre-programmed at the factory and does not require flash programming.Quality AssuranceEach Cardone remanufactured ECM is 100% computer tested, with on-car validation used to confirm durability and performance where applicable. The remanufacturing process also reduces energy and raw material use compared with producing a new part, while maintaining OE-style fit and function for the listed applications.
