Remanufactured ECM for Chrysler and Dodge VansCardone 79-7192V is a remanufactured engine control module built for 1998 Chrysler, Dodge, and Plymouth minivans with vehicle-specific flash programming requirements. It is engineered to restore proper engine management in applications such as the Chrysler Town & Country, Dodge Caravan, Dodge Grand Caravan, Plymouth Grand Voyager, and Plymouth Voyager.Key Features Remanufactured Original Equipment-style ECM for a direct vehicle fit Two rectangular connectors with 40-pin male terminals Aluminum housing for OE-style mounting and durability Critical components are re-soldered or replaced during remanufacturing 100% computer tested for functionality and reliability Flash programming required for vehicle-specific calibration Fits 1998 Chrysler Town & Country, 1998 Dodge Caravan, 1998 Dodge Grand Caravan, 1998 Plymouth Grand Voyager, and 1998 Plymouth Voyager Product DetailsThe Cardone Engine Control Module 79-7192V is a remanufactured ECM designed to meet OE performance expectations while addressing common failure points found in original units. Cardone reverse engineers failed modules to identify design weaknesses, then repairs or replaces critical internal components at its Philadelphia manufacturing plant. This process supports stable electrical connections and consistent operation in Chrysler Town & Country, Dodge Caravan, Dodge Grand Caravan, Plymouth Grand Voyager, and Plymouth Voyager applications.This part cross-references Chrysler OE numbers 4727192AF and 4727192AJ for the same application.Common Problems This ECM Can Address No-start or hard-start conditions caused by a failed engine control module Driveability issues related to incorrect fuel or ignition control Intermittent stalling from internal ECM electrical faults Check engine light concerns tied to module malfunction Communication or calibration problems after ECM replacement Installation NotesPrior to replacement, verify the original ECM is the source of the fault. Common causes of module failure include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. This unit requires flash programming, and Chrysler PCM/ECM applications with a V suffix need VIN programming. Use the correct VIN and mileage data during setup, and confirm the OE engineering number before installation.For Ford and GM anti-theft procedures, follow the OE service information for the specific vehicle. This module is not flashable and does not include mounting hardware.Quality AssuranceEach Cardone remanufactured ECM is computer tested or bench-tested, depending on application, and validated on-vehicle for durability and performance. The remanufacturing process reduces raw material and energy use compared with producing a new part, while restoring the module to dependable service for 1998 Chrysler, Dodge, and Plymouth minivan platforms.
