Remanufactured ECM for Chrysler and DodgeCardone 79-7244V is a remanufactured engine control module built for specific 1999 Chrysler, Dodge, and Plymouth applications. It is designed for direct OE-style fitment, with 2 rectangular connectors, aluminum housing, and 40-pin male terminals for the listed vehicles.Key Features Remanufactured Original Equipment-style engine control module Fits 1999 Chrysler Town & Country, Dodge Caravan, Dodge Grand Caravan, Plymouth Grand Voyager, and Plymouth Voyager 2 connector design with rectangular connector shape Aluminum housing for the listed application Critical components are re-soldered or replaced during remanufacturing 100% computer tested for function and reliability Flash programming required for installation Part number: 79-7244V Product DetailsThe Cardone Engine Control Module line focuses on remanufactured electronic and powertrain control units that are inspected, rebuilt, and tested to restore proper engine management performance. For this application, the module is remanufactured at Cardone’s Philadelphia facility, where weak points found in failed original units are corrected through reverse engineering and component-level repair. This part number, 79-7244V, is listed for 1999 Chrysler Town & Country, 1999 Dodge Caravan, 1999 Dodge Grand Caravan, 1999 Plymouth Grand Voyager, and 1999 Plymouth Voyager with the specified OE references and programming requirements.This part cross-references Chrysler OE numbers 04727244AA and 04727244AE for the same application.What This ECM Helps Address Check engine light concerns related to control module failure No-start or hard-start conditions tied to PCM/ECM faults Driveability issues caused by incorrect fuel or ignition control Communication problems between the module and vehicle systems Failure codes linked to internal module electronics Installation Notes and TipsFits 1999 Chrysler Town & Country, N/A; 1999 Dodge Caravan, N/A; 1999 Dodge Grand Caravan, N/A; 1999 Plymouth Grand Voyager, N/A; and 1999 Plymouth Voyager, N/A, with the listed OE numbers and vehicle-specific flash programming requirements. Accurate VIN and mileage information are required for programming. Chrysler PCM units identified with a “V” suffix need VIN programming. Before replacing the original ECM or PCM, verify power, ground, wiring harness condition, and related solenoids or relays to confirm the original module is the source of the issue.Quality AssuranceCardone remanufactures this ECM to meet or exceed OE performance expectations through component replacement, re-soldering of critical connections, and computer-based testing. On-car validation is used on applicable units to confirm durability and performance before release.
