Remanufactured ECM for Chrysler and DodgeThis Cardone Engine Control Module is a remanufactured ECM built for 2007 Chrysler Town & Country, 2007 Dodge Caravan, and 2007 Dodge Grand Caravan applications with the listed OE numbers. Part number 79-7656V is flash programming required and is designed for vehicles that need a direct-fit engine management replacement.Cardone remanufactured electronic and powertrain control modules are rebuilt to meet or exceed OE performance, with critical components re-soldered or replaced and each unit computer tested for reliability. This product line focuses on correcting common failure points found in original modules while restoring proper engine control operation.Key Features Remanufactured Original Equipment-style ECM for a precise vehicle fit 4 rectangle connectors with 38-pin male terminals on each connector Aluminum housing for OE-style module construction Flash programming required for installation Computer tested for functionality and durability On-car vehicle validation used to verify performance Earth-friendly remanufacturing process reduces raw material and energy use versus new part production Detailed DescriptionThe Cardone 79-7656V engine control module is intended for Chrysler and Dodge vehicles that require a remanufactured ECM with the correct connector layout and programming support. It is a direct replacement for applications calling for OE numbers 5187 656AB, AC, or AD, and it cross-references Dodge 5187656AD for the same application. This part is used in 2007 Chrysler Town & Country, 2007 Dodge Caravan, and 2007 Dodge Grand Caravan with federal emission system coverage where specified.Because this module requires flash programming, accurate VIN and mileage information are needed during setup. The Cardone remanufacturing process addresses common internal failure points by reworking critical electrical connections and validating the unit before release.Common Problems This ECM Can Address Engine no-start conditions caused by a failed control module Intermittent stalling or rough running related to ECM faults Communication issues between the ECM and vehicle systems Check engine light concerns tied to internal module failure Driveability problems after the original module has failed Installation Notes and Tips Fits 2007 Chrysler Town & Country, N/A, with OE # 5187 656AB, AC, AD; vehicle-specific flash programming required on or off the vehicle. Fits 2007 Dodge Caravan, N/A, with OE # 5187 656AB, AC, AD; vehicle-specific flash programming required on or off the vehicle. Fits 2007 Dodge Grand Caravan, N/A, with federal emission system and OE # 5187 656AB, AC, AD; vehicle-specific flash programming required on or off the vehicle. Verify the original failure cause before replacing the ECM; poor grounds, power supply issues, wiring faults, and shorted relays or solenoids can damage the replacement unit. Chrysler PCM units identified with a V suffix require VIN programming. Use the correct OE-approved service information for programming and vehicle-specific setup. Quality AssuranceCardone remanufactured control modules are 100% computer tested, and critical components are re-soldered or replaced during remanufacturing at the Philadelphia manufacturing plant. The process is built to restore OE-level operation while supporting reliable engine management in Chrysler Town & Country, Dodge Caravan, and Dodge Grand Caravan applications.
