Remanufactured ECM for Chrysler and DodgeCardone 79-9506V is a remanufactured engine control module built for specific Chrysler and Dodge applications, including the 2003-2004 Chrysler 300M, Chrysler Concorde, and Dodge Intrepid. It is engineered to restore factory-style engine management performance with application-specific flash programming required.Key Features Remanufactured Original Equipment-style engine control module for a direct vehicle fit Four rectangular connectors with 38 male pin terminals per connector Aluminum housing for OE-style mounting and durability Critical internal components are re-soldered or replaced during remanufacturing 100% computer tested for functionality and reliability On-car validation is used to confirm durability and performance by application Flash programming required; vehicle-specific VIN and mileage data are required for programming Product DetailsCardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are reverse engineered to identify common failure points and correct original design weaknesses. For this application, part number 79-9506V is a remanufactured ECM with four rectangular connectors, an aluminum housing, and no removable PROM. It is built for 2003-2004 Chrysler 300M, Chrysler Concorde, and Dodge Intrepid models listed with the matching OE numbers and requires flash programming before use. This part cross-references Chrysler OE numbers such as 4869506AB and 4896725AA for the same application.Common Problems This ECM Can Address Engine no-start or intermittent start conditions caused by a failed control module Check engine light concerns related to ECM internal faults Driveability issues tied to corrupted module logic or failed circuitry Communication problems between the ECM and vehicle systems Failure caused by heat, vibration, or aged solder joints inside the original module Installation Notes and Tips Fits 2003-2004 Chrysler 300M, N/A Fits 2003-2004 Chrysler Concorde, N/A Fits 2003-2004 Dodge Intrepid, N/A Verify the OE number on the original module before ordering to confirm the correct Cardone 79-9506V application Flash programming is required, and accurate VIN and mileage information must be provided Inspect grounds, power feeds, wiring harnesses, relays, and solenoids before replacing the ECM Some Chrysler PCM units with a “V” suffix require VIN programming For Chrysler, Ford, and GM anti-theft relearn or reset procedures, follow the OE service information for the exact vehicle Quality AssuranceCardone remanufactures this ECM at its Philadelphia facility, where critical components are re-soldered or replaced and each unit is computer tested before release. The remanufacturing process also reduces raw material and energy use compared with producing a new part, supporting a more resource-efficient repair.
