When the pump bushing in a T35 automatic transmission wears past its serviceable limit, shaft movement inside the pump assembly disrupts hydraulic pressure and the entire unit suffers for it. This is the direct replacement pump bushing for T35 applications built between 1964 and 1992, sold as a single piece for technicians who have already diagnosed exactly where the fault is.The pump bushing sits at the inlet side of the hydraulic circuit, and its fit around the shaft governs how consistently the pump can build and hold the pressure that every clutch pack and shift valve downstream depends on. A bushing that has worn loose does not hold the shaft on center, and that off-center movement shows up as inconsistent line pressure, delayed engagement, or slippage under load. Replacing the bushing restores the mechanical relationship the pump was designed around.This listing is for the bushing alone. No seals, no gaskets, no clutch friction discs, no steels, no filter, and no band are included. If your repair also requires those components, source them separately before you start the job so the unit does not sit open while you wait on additional parts.At REMCO, parts are pulled and verified individually at the facility, not shipped straight from a bulk supplier package. The part is checked before it ships. REMCO has been working in automatic transmission parts since 1991, and single-piece orders like this one go through the same process as full kits.Before placing the order, confirm the transmission code on the unit is T35 and that the build year is within the 1964-1992 range. If there is any doubt about the code, pull the tag or stamp from the case before ordering. Restoring proper fluid pressure starts with the pump bushing: worn pump bushings allow shaft movement that leads to pressure loss and slippage inside the unit. This listing covers the pump bushing only. It does not include any seals, gaskets, clutch packs, steels, filter, or band. Verify what your repair needs before ordering. The T35 pump bushing addresses a specific wear point at the pump assembly where shaft-to-bushing fit directly affects hydraulic output and shift behavior throughout the unit. One pump bushing for T35 applications, shipped at 1 lb. Sourced and packaged individually at the REMCO facility, checked against the part record before it leaves. Before ordering, confirm the transmission code stamped on your unit matches T35 and that the production year falls within the 1964-1992 range covered by this part. What's in the box WHAT IS IN THE BOX 1 x Bushing, Pump t-35