Info What Does It Do? Fine pad cleans and shines metals such as aluminum, steel, stainless steel, brass, copper, titanium, and others Rust, corrosion, and minor scuffs can be removed using the coarse pad Mounts on a hand sander or drill adapter pad. Works well for buffing off boot markings on frames and swingarms, or touching up previously finished parts. Also useful for achieving a consistent brushed look on larger parts. Do not use these pads on a die grinder, dremel, or bench grinder. Related Items Cleaning Pad Hand Kits are available here Cleaning Pad Drill kits are available here Hand sanders are sold here Drill adapter pads are sold here Click on "Video" tab to see the pads in use. Specs Specs Available in 3" and 5" sizes Coarse pad (Green) is equivalent to 240 grit Fine pad (Red) is equivalent to 400 grit Pads are attached using a hook and loop style Available in singles, or in packs to save you some cash! Max RPM: 4000 These pads are made from a nylon strand material that is embedded with resin and an aluminum oxide abrasive for optimal stiffness and abrasion. How To Use How To Use Use these pads by hand with a hand sander or on a drill using a drill adapter. If using a drill, here's a cheap drill that works great with these pads. Harbor Freight Drill Hand Buffing Tips Attach pad onto hand sander. Use coarse pad to remove corrosion, rust, and light scratches. These pads will not remove deep scratches or casting lines. Use a flap wheel, sandpaper, or coarse cleaning wheel for scratch and casting removal. The fine pads wear quicker, so only use when giving your part a finishing shine. Remove as much grease, oil, and dirt as you can before using the pads, so you’re not contaminating them. Try to buff evenly across the part so you don't end up with dips or low spots. Sand or buff in the same direction if you’re going for a brushed look. Intersecting scratches do not look good. Use only light to medium pressure with the pad or you'll wear it out prematurely. If you need to apply heavy pressure, you should go to a more aggressive pad. In order to make the pads last as long as possible, be careful around sharp edges. To achieve a higher shine and smoother finish, buff with a lubricant such as Maxima MPPL or WD40. Always wear a dust mask or respirator and eye protection while buffing! Drill Buffing Tips Installation Attach pad onto adapter. Slide adapter shaft at least 3/4" into drill, securely fasten, and get cleaning! Buffing Use coarse pad to remove corrosion, rust, and light scratches. These pads will not remove deep scratches or casting lines. Use a flap wheel, sandpaper, or coarse cleaning wheel for scratch and casting removal. The fine pads wear quicker, so only use when giving your part a finishing shine. Remove as much grease, oil, and dirt as you can before using the pads, so you’re not contaminating them. The pads work best at 2000-3000 RPM, so turn your drill to the speed setting. Try to buff evenly across the part so you don't end up with dips or low spots. Use only light pressure with the pad or you'll wear it out prematurely. If you need to apply heavy pressure, you should go to a more aggressive pad. In order to make the pads last as long as possible, be careful around sharp edges. To achieve a higher shine and smoother finish, buff with a lubricant such as Maxima MPPL or WD40. Always wear a dust mask or respirator and eye protection while buffing! Video Tags: Cleaning, Pad, Wheel, Scuff, Scotch, Abrasive, Buff, Buffing, Scotch Brite Wheel, Scotch Brite Pad, Abrasive Wheel, Abrasive Pad, Buffing Wheel, Buffing Pad, Sanding Pad, Scuff Pad, Scrub Pad
