The Colour Forge - Desert Sand Spray Primer The Colour Forge Desert Sand Spray offers exceptional coverage and quality. With a proven formula, this product delivers performance comparable to the best in the industry. It provides a smooth, warm sandy base coat, perfect for desert themes, basing, uniforms, or specific army schemes requiring a light, earthy tone. This spray is colour-matched to Games Workshop's Zandri Dust, making it an excellent alternative. Get more with the generous 500ml spray can – that's 25% more paint than many standard brands! For the Best Results: Shake Well: Shake the can vigorously for at least 2 minutes to ensure the pigment is fully mixed. You should hear the agitator ball moving freely. Warm Gently: If the can feels cold, stand it in a container of warm (not hot!) water for a few minutes. Keep the water level below the nozzle area. This improves paint flow, especially in cooler conditions. Test Spray: Briefly spray onto a piece of scrap material to ensure an even flow. Apply: Hold the can approximately 15-25 cm (6-10 inches) away from the model. Apply using short, even passes, moving across the model. Aim for thin coats – it's better to apply two thin coats than one thick one. Allow drying time between coats if needed. Clear Nozzle: After use, turn the can upside down and spray for a few seconds until only clear propellant comes out. This helps prevent nozzle blockages for next time. Safety Information: Not suitable for children under 36 months. Keep out of the reach of children. Danger! Extremely flammable aerosol. Pressurized container: May burst if heated. Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Causes serious eye irritation. May cause drowsiness or dizziness. Repeated exposure may cause skin dryness or cracking. Use only outdoors or in a well-ventilated area. Avoid breathing vapor/spray. Wear protective gloves/protective clothing/eye protection/face protection. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Dispose of contents/container in accordance with local regulations.
