PROPER WASHING IS KEY. Most swirls come from dragging grit across the paint during the wash. This kit is built to stop that before it happens: a full foam blanket to break dirt loose, separate pads for upper and lower panels, and a heavy duty foam cannon to lay it all down. Built for pressure washer users. The pre soak matters: The Foam Thrower lays down a thick, even foam blanket across the whole vehicle before your mitt ever touches the paint. That foam breaks contaminants loose so they rinse off instead of getting dragged across the clear coat. Separate pads, upper and lower: Four Flat Out Wash Pads for the top half of the vehicle where paint stays cleanest. The Block Party Wash Block handles the lower panels, where rocker grime, fender well spray, and road film live. Keep them separated and grit never touches your hood. Real foam cannon, adjustable: The Foam Thrower connects to a pressure washer, with adjustable fan and foam output so you can dial coverage for a maintenance wash or a full decon job. Heavy duty construction, not a throwaway plastic cup. Kit includes: (4) Flat Out Wash Pads (1) Block Party Wash Block (1) The Foam Thrower (1) Hot Shot Soap, 16 oz. How to Use Step 1: Foam Fill the Foam Thrower bottle with 2 to 4 oz of Hot Shot Soap and fill the rest with water. Adjust the fan and foam output. Lay a full, even foam blanket across the entire vehicle. Go into your contact wash. Step 2: Contact Wash Use a Flat Out Wash Pad on the top half of the vehicle. Rotate pads as they load up. Use the Block Party Wash Block for the lower panels, rockers, and bumpers. Rinse the vehicle thoroughly and dry with a clean microfiber or air blower. Detailer Tips Pressure washer required. The Foam Thrower is a cannon, not a gun, it needs a pressure washer to produce proper foam output. If you're on a garden hose setup, this isn't the right kit. Keep upper and lower pads separate. Flat Out pads stay on the top half, Block Party stays on the bottom. Don't mix them, that's how grit ends up on your hood. Flip the pad to a clean side after each panel. Once both sides have been used (one panel per side), grab another pad. Working with hard water in direct sun? Wash in sections so soap and water don't dry on the surface before you can rinse, that's how you get hard water spots. Rinse the Foam Thrower after every use. Keeps the cannon performing and prevents soap residue from drying in the bottle or nozzle.
