FEATURES Microprocessor based trim tab control with LED tab position indicators Single button press to move both tabs up or down simultaneously Direct replacement for Oval LED (SETR-61) controls Automatic return to last tab position if ignition key is turned off and back on again Completely sealed, completely waterproof and will not deteriorate in sunlight Automatic tab retraction and calibration with key or accessory switch off Easy upgrade from rocker switch style control No external power module required for single or dual actuator per tab systems LED tab position indicators dim automatically in darkness and brighten in sunlight Adjustable programming features located on back of specification sheet Operates on 12 or 24 volt dc systems SPECIFICATIONS Model Number Display Color Number of Stations / Actuators Overall Width Overall Height / Thickness Mounting Hole Cutout (Diameter) DC Voltage Fuse Size Power Input (1 Actuator per Tab) Fuse Size AUX Terminal (MUST CONNECT) SLC-11 Black 1 or 2 Stations / 1 or 2 Actuators/tab 3.0" / 77mm 3.0" (77mm) / 437" (11mm) 2.25" (57mm) to 2.5" (64mm) 12/24 12vdc = 15 or 20 amp24 vdc = 10amp 1 to 2 amp SLC WIRING and DIMENSIONS SLC PROGRAMMING Program Mode Sequence Setting Enter Change Setting Exit and Save Range Default Program Details Timing Port Bow Down Press and hold Stbd. Bow Up/Down Port Bow Up 4 - 12 seconds 8 sec. 8 LED's = 8 second actuator4 LED's = 4 second actuator Swap LEDs Starboard Bow Down Stbd. Bow Up/Down Port Bow Up LEDs opposite or same side as button press LEDs opposite 1 LED each side = LEDs opposite button press / 8 LEDS each side = same side Remember last tab setting Port Bow Up Stbd. Bow Up/Down Port Bow Up Standard retract / Remember last tab setting Standard 8 LEDs each side = Standard / 1 LED each side = Remember last tab setting Disable Auto Tab Retract All Up and All Down Simultaneously for 2 seconds or longer Stbd. Bow Up/Down Port Bow Up Enable / Disable Enable 1 LED each side = Auto Tab Retract Enable / 8 LEDs each side = Auto Tab Retract Disable Enter, Adjust and Exit Program Mode: Before entering program mode, 12vdc or 24vdc must be applied to Oval main power Power to AUX terminal must be OFF (Aux is typically connected to ignition key switch or aux switch) Press and hold button noted in Programming chart under column “Enter” for more than 2 seconds while switching the Aux terminal switch to ON at the same time Release the “Enter” button and press “STBD BOW UP or DOWN” button to change the value Press and hold “PORT BOW UP” for more than 2 seconds to exit program mode
