Wraps are sized for 20oz stainless steel tumbler. Application instructions listed below are to be used as a point of reference only. Temperature and time settings may differ depending on which sublimation heat press or convectional oven you use. Application instructions: ALL SUBLIMATION WRAPS HAVE BEEN MIRRORED AND READY TO PRESS * Preheat heat press to 350 F. Heat press pressure should be set at medium/high 1. Measure wrap around your stainless steel tumbler. 2. Trim excess ends of sublimation paper as needed. 3. Using heat resistant sublimation tape, place wrap around tumbler (make sure it fits tight around the tumbler). 4. apply heat tape on both ends of tumbler. 5. insert tumbler into heat press for rotate tumbler in heat press 3 times. 6. Each time tumbler is rotated it should be left in heat press for 45 seconds, each side. 7. remove tumbler from heat press using heat resistant gloves. 8. place tumbler in a safe area away from any children. (these are very hot!) 9. wait until it cools down then peel of sublimation paper.
