Get guaranteed professional results every time with the Cramer Professional Kit. Provides clean and permanent seals. A releasing agent (soapy water) is not needed to apply the soft caulking mass (silicone). This process results in optimum adhesion and therefore prevents mould from forming underneath. Blemishes can easily be redone without removing the entire profile. It is incredibly simple and easy to use. These tools can be washed off, re-used also. Optimum protection against bacteria and fungi Used to push sealant deep into the joint Saves time as no masking is required Simple grouting in small sections Imperfections can be easily reworked Versatile in use thanks to 16 profile variants Suitable for all sealing compounds - For easy use of flexible sealants, ms polymers and caulks Instructions: Remove old silicone carefully with a caulking knife with saw blade, for residue use a scraping blade. When removing old mildew stained grouts or caulks, wear a protective mask. On scratch-sensitive surfaces (acrylic or plastic) use a chemical silicone remover. First clean the surface then choose the right caulking profi le and apply silicone on a distance of 60-120 cm. Now make sure that both FUGI edges touch both wall and fl oor, slightly press the FUGI and pull – always only use the smooth FUGI edge for spreading. Start again for a new line section behind the point at which you just stopped and repeat the process. To bridge across vertical grouts hold the FUGI at a slight angle and cross over the grout-line. By doing so you will keep a uniform grout-pattern profi le. When working on corners, fi rst start with the vertical wall grout lines and let them bond. Then proceed to the fl oor-grout starting out of the corners in both directions. Clean the FUGI after usage with household paper towel.
Related
Related
Related
Related