This part allows for drone manufacturers to comply with FAA "Standard" Remote ID. It does not allow hobby or commercial users to comply with FAA "Broadcast" Remote ID. A flight controller running Ardupilot is also required. CubePilot Cube ID Serial is a small size (25mm * 13.75mm * 3.5mm ) Remote ID which broadcasts information about UAVs in flight through a Bluetooth 5.2 dual-mode unit and supports Serial protocol. Users can write different codes with one Cube ID only, to adapt to multiple UAVs based on their needs. CubeID is FCC and CE certified. Features Different codes with one Cube ID only CubeID is FCC and CE certified Bluetooth 5.2 dual-mode unit Supports Serial protocol Small size Specifications Bluetooth chip: Nordic NRF52840 (Bluetooth 5.2 ) Dimension: 25mm * 13.75mm * 3.5mm Operation Temperature: -40°C ~ 85°C Weight: 10g (with cable and antenna) Frequency: 2402MHz ~ 2480MHz Protocol: Serial IMPORTANT NOTES Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Links Installation, settings and updates. Includes 1x CubePilot Cube ID Serial 1x Cube ID to GHR-6 Cable 1x Cube ID to GHR-8 Cable
