The Iron Wolf Conversion Kit is a comprehensive bundle of components specifically for Questor Class Knights, which include:- Custodian Eagle Head- Custodian Shoulder pad plain- Custodian Shoulder Pad with Banner- Set of Eagle Claws- Crotch Plate- Set of Hip Plates- Set of Knee Fan Plates- Set of Shin Plates- Set of Toe Guards Attaching Instructions for head1) Glue the wire bundle to the section where the head is normally attached.2) I have designed the head to swivel, and be removable by using small magnets.3) I have included the link to these magnets here. Two of these small 3mm magnets are required.4) The two small pipes that normally link to the front of the skull head can be glued onto this replacement head instead.5) You can also glue the head in place and skip the magnets completely, though it WILL NOT rotate. Attaching Instructions for Eagle ClawsThe Fingers and Thumb fit into the slots found on the stock Powerful Fist found on the model.Attaching Instructions for Crotch PlateAssemble the Crotch plate in the location where the stock plate typically fit.Attaching instructions for Hip Plates:May be attached to the top portion of the Knight's hip area.Attaching instructions for Shin Plates:These replace the stock shin plates just above the feet. Note they may collide with the stock knee pads included with the model.Attaching instructions for Knee Fan plates:These pieces may be attached on the round knee joint but may fit elsewhere on the model.Attaching instructions for Toe Guards:Place these plates over the top of the models individual toes.Attaching Instructions for Left & Right Shoulder Pads:The shoulder pad fits on the right and left side of the model interchangeably, where the stock shoulder pads are meant to fit.These parts have been designed by Iron Wolf Minis, and have been licensed for a limited time, to Pop Goes the Monkey. Monkey Resin 3 is a high-quality, UV-cured resin designed for strength, impact resistance, and precise detail reproduction. Its low shrinkage rate prevents distortion or loss of fine features while providing a refined surface with stunning details. These parts will arrive attached to their support structure, ensuring all components remain secure during transportation. Most parts can be easily removed by hand; however, if you soak them in hot tap water for 5 minutes, they will come off much easier. Some attachments may require snippers or a hobby knife for a cleaner detachment. Please make sure you use sharp tools carefully to avoid injury. Once removed, all products are pre-cleaned and ready for primer and paint. Use only super glue to adhere these parts to your models. *NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.
