Synthetic Clay Towel 3.0 — Fast, Paint-Safe Decontamination The Synthetic Clay Towel 3.0 lifts bonded contaminants that washing can’t remove — road film, overspray, rail dust, resin — leaving paint smooth and ready for polishing or protection. Its advanced polymerized “clay” face speeds up decon over large areas while the microfiber backing keeps it easy to control. Why You'll Love It Rapid decon on hoods, roofs, doors, glass — much faster than traditional clay bars. Reusable & rinse-clean — simply rinse the pad as it loads; long service life with proper care. Low grab, high control — designed to glide smoothly when properly lubricated. Versatile — safe on paint and glass when used on cool panels with adequate lube. Specs Face: Synthetic polymer “clay” on microfiber backing Size: approx. 30 × 30 cm (12 × 12 in) Use: Paint & glass (spot-test on sensitive finishes) Pairs Well With Chemical decon first: PURGE — pH-Neutral Iron & Fallout Remover Clay lubricant: GLAM — Quick Wax Detailer (excellent clay lube) Wash before/after: FOMO — pH-Neutral Car Shampoo or ORIGIN — Detailing Shampoo Finish protection: PRODIGY — Hybrid Wet Coat Protection How To Use Pre-wash & wash: Knock down grime, then wash with FOMO or ORIGIN; rinse thoroughly. Chemical decon (recommended): On cool panels, apply PURGE, allow reaction, rinse. Lubricate: Mist a small section generously with GLAM (or rich shampoo solution). Glide towel: Lay the Clay Towel 3.0 flat, glide in straight lines with light pressure until smooth. Rinse the towel frequently. Wipe & inspect: Buff dry with a clean microfiber; check under proper lighting. Protect: Apply PRODIGY, a wax, or your preferred coating. Care Tips Always work on cool panels, out of direct sun. Do not use dry. If dropped, rinse the towel and polymer face thoroughly before reuse. Rinse clean after sessions; store flat, polymer-side up, in a cool, dry place. Notes: Not for matte/satin finishes or fresh paint; spot-test PPF and sensitive plastics. Use adequate lubrication to avoid marring.
