Our most cost-effective, high quality oil for exterior use on softwood decking and all large areas of softwood, including cedar cladding, fences, sheds etc. Bestwood Decking Oil is specially developed for use on softwood decking, to give superior weather protection and outstanding value for money. Our Decking Oil penetrates deep into wood, lining the tiny capillaries and replacing natural oils to protect from within, and help prevent water ingress, but it still allows the wood to 'breathe'. It has the following benefits: Dries clear, with a matt wet look. Keeps wood supple. Prolongs maintenance life and protects colour. Will not, flake peel or blister. Easy to apply. Adds protection against algae and fungi. Dirt resistant. Greatly reduces warping and splitting. Adds UV protection. Can be brushed sprayed or dipped. Works with pine, cedar, larch etc. Important: Decking Oil is made to penetrate into the wood, and is not suitable for wood that has already been sealed with paint or other coatings, or hardwood that is high in tannins or resin. Please note: Bestwood Decking Oil is not designed for use with high tannin or very resinous hardwoods, like oak, teak, iroko etc. For these woods we would recommend Bestwood Danish Oil or Bestwood Teak Wood Oil. Bestwood Decking Oil should not be used on previously painted waxed varnished or sealed wood, as it is made to penetrate deep into the wood and protect from within. Any existing coatings should be removed before applying Decking Oil and a trial area should be applied. Surface preparation Bestwood Decking Oil will enhance the existing colour of the wood. For best results aged and grey timber should be cleaned, and sanded if necessary, back to 'bright' wood. All dirt, algae, mould etc should be removed using Bestwood decking cleaner. New decking can sometimes 'repel' oils due to the nature of the preservative treatments that is often used, especially if the wood is saturated with water based preservative, or it has not fully dried out. We would recommend applying a small test area to make sure the oil penetrates to do its job, If the oil appears to sit or float on the surface with the first coat, it may be that the wood is damp or saturated and needs to be left to fully dry out before oiling. Application. Apply a full even coat by brush, roller or spray. Leave for 30-40 minutes to allow the oil to penetrate, then reapply additional coats as necessary. The wood is sealed once the oil stops soaking in. Remove any oil from the surface of the wood with a lint-free cloth, eg t-shirt material and leave overnight to dry. Reapplication is recommended every 3-4 years, but some users like to re-oil once a year, and that's fine. Cleaning the wood every year will keep your decking in tip-top condition. Please remember that oil and water don't mix! Do not apply when the wood is damp or wet, or when frost, condensation or rain are likely within 48 hours of application. Bestwood Decking Oil will restore the colour of the wood, please test on an inconspicuous area to make sure you get the results you want. A wet surface will give an idea of the depth of colour that oiling will give Coverage: Coverage will vary depending on the type of timber, its profile, dryness etc. Typical coverage is approximately 5 square metres per litre. Clean up. Wash brushes in white spirit or use a good quality brush cleaner. Precautions. Wear suitable clothing and gloves when using Bestwood Decking Oil. Store upright under cover away from extremes of temperature (eg direct sunlight and frost). Keep the lid tightly on the container when not in use. Quality Packaging We use quality 'UN approved' containers for our Decking Oil. In the unlikely event of a leak in transit, please contact us for a full refund/replacement.
