Deutsch Plug Surface Mount A clean, secure way to mount one Deutsch DT plug on your canopy, tray, toolbox, caravan, camper trailer or 4WD setup. This mount holds one Deutsch DT plug in the pin count you choose, from 2 pin to 12 pin. Common uses include canopy wiring, lighting circuits, switch wiring, accessory wiring and other low-current 12V connections. Custom Labels Optional front labels can be added to identify each circuit. Labels are entered from left to right as viewed from the front of the mount. What's Included 1x Deutsch Plug Surface Mount 1x Flexible TPU mounting gasket M5 countersunk stainless mounting hardware Note: Deutsch plugs and dust covers are sold separately. Made in Australia Designed and made in Australia by AFS Offroad from ASA-GF, a strong UV-resistant material suited to outdoor use. The included Flexible TPU mounting gasket is selected for flexibility, heat resistance, UV resistance and outdoor 4WD/canopy installs. What Plug Do I Need? Choose the Deutsch DT pin count to suit your wiring setup. Option Typical use 2 Pin DT Simple positive and negative accessory wiring 3 to 12 Pin DT Multi-wire accessories, switch panels or control wiring If unsure, match the mount to your existing plug size, pin count and wiring requirements. Key Features Holds one Deutsch DT plug, 2 to 12 pin Extra cable clearance behind the plug Built-in dust cover cable cutout where applicable Optional front labels to identify each circuit Clean rounded shape for a neat finished look Installation The countersunk mounting holes allow the mount to clamp down evenly over the gasket. Snug the screws down; no need to overtighten. View the Surface Mount Installation Guide. Backed by our 30-day change-of-mind returns, plus full cover for any fault under Australian Consumer Law. Important: water protection and electrical installation Not waterproof: Dust covers, mounting gaskets and connector mounts do not create a waterproof or watertight seal. Install them in a protected location away from direct spray, high-pressure water and immersion. Qualified installation required: All electrical wiring and installation must be carried out by a suitably qualified electrician or auto electrician, as appropriate. The installer must select correctly rated cable, terminals, fusing and circuit protection for the application.
