This convenient bundle includes the DG Pack, complete with the harness system, lid, load shelf and DEI 1606MC Frame. FEATURES: 65/85 litre main pack Use with external frames: DEI 1606-MC frame, ALICE or Palice. (Load shelf only compatible with DEI 1606-MC) Tab and Loop side compression Modular exterior to affix pouches Removeable lid with internal retention and an exit port for a hydration bladder Ergonomic, structured harness that can be adjusted for the user's height Carry handles on top and each side (note: straps are not designed to be a lifting point) Hip belt can be worn around the waist for weight distribution or tucked away to allow the pack to be worn with belt order Zippered exit ports for hydration and communications equipment Strap management on all adjustable straps Roll top lid that is water resistant and allows for expansion when necessary Top draw cord and compression strap SPECS: MAIN PACK CAPACITY: Compressed state: 65 litres Uncompressed state: 85 litres With roll top extended: 125 litres Size of main body of pack: H: 100cm, L:44cm, W: 16cm, H: 125cm when extended. MATERIALS: 330d solution dyed Cordura 400d oxford nylon 500d solution dyed Cordura 1000d solution dyed Cordura Anti-microbial air mesh Polyethylene foam A-A-55301 webbing ITW and Milspec fastenings and fittings FRAME The DG pack is designed around the Down East Incorporated 1606-MC frame, which is issued to the United States Marine Corps. It is made with a fragmentation-resistant polymer and is designed to support loads of more than 90kg. The frame features designated attachment points for ease of modularity. The DG pack can also be used with ALICE and Palice frames. You just can't use the DG Load carrying shelf with any other frame than DEI 1606MC. SIZING: Suspension system: OSFA Harness Small/Medium: 175cm and shorter Harness Large/XLarge: 176cm and taller The table below is a guide for setting the harness to the correct height utilizing the suspension system. Individuals wearing belt order should use the shorter setting below their height to allow the pack to sit upon and be supported by the belt order. The bartack to the top of the harness is: Note: Users 185cm and taller should use position 5 and the optional tall mount ladder-locks above the exit zips on the pack body. This negates being able to use the load shelf feature. FITTING GUIDE: CARE AND MAINTENANCE: 1. Remove built-up dirt with a soft or medium-soft hand brush.2. Wash off the dirt with lukewarm water to 30°C, using a hand brush if necessary. For heavier dirt, a mild detergent with no chlorine or bleach can improve the result.3. We recommend that the pack and pouches be allowed to dry slowly and not be placed in the sun or on a heater.4. When everything is completely dry, the fabric can be treated with Grangers tent + gear repel to aid water repellence.5. For the zippers, a light spray of silicone on the teeth and slider is recommended. As always, the DG pack, pouches and harnes system is designed and made in Christchurch, New Zealand by TwinNeedle. DEI 1606-MC Frame is designed and made in the US by Down East Innovation.
