EQ-Die-10S is a small pressing die with a 10 mm I.D x 20 mm H for thin pellets and high-throughput pressing by a 100T hydraulic press machine, which can press 32 pcs of pellets at one time.SPECIFICATIONS: Pressing die installation schematic To avoid the risk of accidents and damage to the Pressing Die, please read these instructions carefully before installation and before using it for the first time. Must read the manual, especially the die installation schematic, before operation. The operator must wear protective goggles. Must have a Hydraulic Pellet Press equipped with the Protection Cover Material Made by High-stretched Carbon Steel Hardness HRC 60-62 Roughness Average (Ra) 0.08 μm Maximum Load 5 metric Ton (at room temperature) 630 MPa Weight 0.4 Lbs The whole set pressing die includes One 10mm I.D. core die One steel sleeve for the core-die protection Two pushing rods, highly polished and perfectly fitted into the die. Cautions WARNING: It would be best if you put the die in the center of the pressing machine, it may cause the pushing rod to crack. DO NOT press flammable, corrosive, or explosive materials The operator must wear protective goggles. Attention: Use ethanol to clean the pressing die before and after use every time Use anti-rust oil after the operation and store it in a dry place to avoid rusting. NO pressing powder with particle size LESS THAN 30 microns should be used. Small particles may slip into the gap between the pushing rod and steel sleeve and cause damage to the sleeve during compression. Ball mill or grind the powder to the size of 32~75 microns before pressing. 3'' Dia. Sieve Set No. 200 & 450 mesh can be used to separate the 32~75 micron particles from the powder clumps You may consider using BNMR for easy mold release. Please click the picture below to order. Steps to make pellets Mix and grind the chemical powder using an agate mortar or Ball Mill Calcining the mixed powder in a high-temperature furnace at a suitable temperature Crush and grind the calcined powder again by gate mortar or Ball Mill Put the calcined powder into the die Press the sample with a pressing machine under suitable pressure Take out the pellet sample from the die Sinter the pellet at a suitable temperature in an oven Then, a new material sample is formed!
