Module A-165-2 includes six modification circuits for digital signals (clock, gate, trigger, start, stop etc.) which are derived from the two input signals Input 1 und 2: inverted signal of Input 1 (labelled 1) inverted signal of Input 2 (labelled 2) T flipflop (toggle flipflop), controlled by Input 1, this output changes it's state whenever a the rising edge of Input 1 appears (labelled 1/2, as it works similar to a 1:2 frequency divider) Set/Reset flipflop, this output changes it's state to "high" during the rising edge of Input 1 and turns "low" during the rising edge of Input 2 (labelled RS) inverted output of the Set/Reset flipflop (labelled RS) pulse output, during both the rising and falling edge of Input 1 a short trigger pulse with about 50 ms lenght is generated (labelled with the sign ± and a rectangle pulse symbol) The outputs 2, 1/2, RS and the pulse output are equipped with LEDs that display the state of the output in question.The output level for all six outputs can be set to 0/+5V or 0/+11V by means of a jumper or wire on the pc board. Voltage thresholds for the input voltages: voltages below +0,8 V are treated as "low" voltages above +3 V are treated as "high" Typical applications starting and/or stopping of events or switching operations with the RS or RS output (e.g. controlled by the trigger outputs of a sequencer, e.g. in combination with electronic switches) generation of inverted digital signals frequency division (1/2 output) generation of short pulses during the rising and falling edge of a digital signal (e.g. triggering an envelope at both rising and falling edge of a gate signal). Width: 2hp Depth: 45mm Power: 30mA @ +12V, / 0mA @ -12V
