Adding undermount hardware to your cabinet drawers just got easier. The Cantek JEN60 Drawer Notcher is designed to both notch and drill drawer boxes to install undermount soft-close drawer slides. The operation of the machine is simple with a self-indexing drilling unit that’s determined by the position of the drawer for either left or right notching. With a cycle time of approximately 10 seconds per drawer, you can achieve a high throughput and save time for other important tasks. Why Cantek JEN60 Drawer Notcher? High production capacity of up to 220 drawers machined per hour. 57mm (2 ¼”) wide cutter head allows you to machine notches for a wide range of undermount drawer slides without needing to change heads or machine the component twice. Self-indexing drill unit for left or right drawer notching. Convenient foot pedal operation lets operator efficiently load and unload drawers for higher output. Pneumatic cutter & drill stroke by foot pedal operation. Cutter stroke and drill speed are adjustable for optimum finish results Drill will automatically position for both left and right drawer notches by activating a switch in the fence Machine will not cycle unless a drawer is up against the switch for safe operation Insert knife cutterhead with solid carbide inserts for optimum finish results and long tool life 2 ¼” (57mm) wide cutter allows for a wide range of undermount slides Comes with insert cutterhead with inserts and ¼” (6.3mm) solid carbide drill bit. Capable of notching up to 220 drawer boxes (both left and right) per hour. Main cutter motor 3 HP Notch dimensions 2 ¼” (57mm) x 0.5” high Cutter diameter 10” Drill diameter ¼” Table size 49” x 22” Table height from floor 32” Dust port 4” (670 CFM requirement) Compressed air required 90 – 100 PSI Machine dimensions 48” x 37 ¾” x 39 ¾” Machine weight 506 lbs.
